Amana Dryer Parts

Thermal fuse. If the dryer overheats, this device stops the flow of electricity to the heat source and/or the entire dryer. It is located on the blower housing and cannot be reset. The most common cause for overheating is a vent tube clogged with lint, a birds nest or other debris.

Manufacturer Number 3392519

Watch our “Part Testing” video to determine if the thermal fuse has blown out and needs to be replaced.

Dryer belt. This is the most common belt used on Whirlpool, Kenmore, Kitchenaid, Roper, Estate and other dryer brands. The belt is flat, 92-1/4 inches long, 1/4 inch wide and has 4 ribs and 3 grooves. It replaces many other belts, including some with 5 ribs and 4 grooves.

Manufacturer Number 341241

See our dryer belt diagram to see how this belt should be installed around the motor and idler pulleys.

Gas burner valve solenoids. Kit contains both the two wire and three wire solenoids. One solenoid is the primary and one is the safety. Both have to operate for the gas valve to open. Usually, one of them burns out but you should always replace them as a set.

Manufacturer Number 279834

These often fail intermittently, making diagnosis difficult. To test, watch the burner assembly while the dryer is heating. If the igniter glows for a while and then shuts off without the gas turning on, it usually means one of these coils is bad.

Dryer heating element. If your dryer does not heat, enter your model number into our Repair Help Section as this part is not the most common cause.

Manufacturer Number 279838

Normally, if you remove the old element a defective part will have a physical break in it. It can also be tested using a multimeter.See our Repair Help section for additional information

Igniter kit, will replace round or flat style, with bracket, wire nuts and mounting screw. Caution! The black heating element portion of this part is EXTREMELY fragile. Use caution when handling.

Manufacturer Number 279311

Watch our “Part Testing” video to determine if the dryer igniter has burned out and needs to be replaced.

Drum support roller

Manufacturer Number 37001042

Dryer belt, length 93 3/8”, width 3/8”, characteristics, 5 ridges, flat

Manufacturer Number 40111201

Door switch assembly

Manufacturer Number 3406107

Dryer cycling thermostat with internal bias heater, L155-25

Manufacturer Number 3387134

Heating element thermal cut-off (thermal fuse) 309 degrees and high-limit thermostat 250 degrees, with wiring kit.

Manufacturer Number 279816

Watch our “Part Testing” video to determine if the thermal fuse has blown out and needs to be replaced.

Heating element assembly, 240 volts

Manufacturer Number 3387747

Watch our “Part Testing” video to determine if the dryer heating element has burned out and needs to be replaced.

Dryer thermistor assembly

Manufacturer Number 8577274

The thermistor should read approximately 11.9K Ohms of resistance at 21 degrees Celsius (70 degrees Fahrenheit).

Drum glide pad (Replace in Pairs)

Manufacturer Number 37001298

Belt tension pulley

Manufacturer Number 691366

Plastic leveling leg

Manufacturer Number 49621

Rear drum support roller kit (2) in kit, Whirlpool-Kenmore, and others

Manufacturer Number 349241T

Dryer belt, length 93 1/2”, width 1/4”, characteristics, 4 ridges, flat

Manufacturer Number 661570

Repair kit for Whirlpool, Kenmore, Roper dryer; rollers, belt and idler pulley, for 29" wide Dryers built 1965 and later

Manufacturer Number 4392065

Universal door catch kit

Manufacturer Number 279570

Lint filter

Manufacturer Number W10120998

Dryer belt tension pulley wheel

Manufacturer Number 279640

Thermal fuse, high-limit thermostat kit for gas/electric dryer

Manufacturer Number LA-1053

Watch our “Part Testing” video to determine if the thermal fuse has overheated and needs to be replaced.

Motor, dryer drum drive with pulley for belt

Manufacturer Number 279827

Gas dryer sensor for igniter and flame

Manufacturer Number 338906

This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Blower wheel retaining ring

Manufacturer Number 25-7855

LP conversion kit

Manufacturer Number 49572A

Drum support roller. *Tri Rings not included, see Related Items below.

Manufacturer Number W10314173

High-limit thermostat, L250-80, with terminal extension arm

Manufacturer Number 3977767

This thermostat should be closed for continuity at room temperature, opens at around 250 degrees Fahrenheit. Check for continuity with a multi-meter before replacing.

Idler pulley wheel and bearing assembly

Manufacturer Number Y54414

Idler pulley assembly

Manufacturer Number 37001287

Thermal fuse

Manufacturer Number 40113801

Watch our “Part Testing” video to determine if the thermal fuse has overheated and needs to be replaced.

Bracket

Manufacturer Number W10547290

Heating element

Manufacturer Number 35001247

Watch our “Part Testing” video to determine if the dryer heating element has burned out and needs to be replaced.

Lint filter

Manufacturer Number 53-0918

Lint filter assembly

Manufacturer Number 37001142

Tri-ring retainer for support roller

Manufacturer Number 690997

Light bulb, 10 watt

Manufacturer Number 22002263

Moisture sensor bar

Manufacturer Number 3387223

Blower wheel

Manufacturer Number 694089

Door catch kit, includes catch and clip (metal)

Manufacturer Number LA-1003

Retainer snap ring

Manufacturer Number 23748

Timer, 60 hertz

Manufacturer Number W10185972

Rear felt seal with adhesive

Manufacturer Number 279857

White touch-up paint

Manufacturer Number 72017

Thrmst-fix

Manufacturer Number W10423382

High limit thermostat and thermal fuse kit

Manufacturer Number 279973

Watch our “Part Testing” video to determine if the thermal fuse has overheated and needs to be replaced.

Push to start switch

Manufacturer Number 3977456

Watch our “Part Testing” video to determine if the switch has failed and needs to be replaced.

Idler wheel/drum roller shaft

Manufacturer Number 56461

Door switch kit. *Replaces older 2 terminal switches.

Manufacturer Number W10169313

Cylinder felt seal

Manufacturer Number 37001132

Front panel retainer clip, 1 per pack

Manufacturer Number 3394083

Heater element

Manufacturer Number 8544771

Watch our “Part Testing” video to determine if the dryer heating element has burned out and needs to be replaced.

Washer 3/4 inch outside diameter

Manufacturer Number 233520

LP conversion kit

Manufacturer Number W10317689

Felt pad

Manufacturer Number 510189

Door catch kit, includes catch and clip (plastic)

Manufacturer Number 306436

Drum support roller kit with axles and mounting screws. Kit has been updated it has 1 plastic spacer that is the thickness of 2 spacers.

Manufacturer Number LA-1008

Drum support roller axle

Manufacturer Number 40113601

Rubber leveling leg foot.

Manufacturer Number Y314137

Heating element assembly with replacement high limit thermostat, L248-80 (240 Volt-4750 Watt)

Manufacturer Number LA-1044

Watch our “Part Testing” video to determine if the dryer heating element has burned out and needs to be replaced.

Motor, dryer drum drive

Manufacturer Number 279787

Motor pulley, 60 hertz

Manufacturer Number 8066184

Gas dryer igniter (Bracket is no longer included.)

Manufacturer Number 37001308

Watch our “Part Testing” video to determine if the dryer igniter has burned out and needs to be replaced.

Drum seal kit. Includes silicone rubber adhesive.

Manufacturer Number 280114

Heating element

Manufacturer Number Y503978

Watch our “Part Testing” video to determine if the dryer heating element has burned out and needs to be replaced.

Top panel spring clip

Manufacturer Number 18776

Drive motor assembly with pulley

Manufacturer Number 2200376

Bracket, cylinder glide

Manufacturer Number 37001036

Blower wheel clamp

Manufacturer Number 312967

Igniter assembly for dryer gas burner.

Manufacturer Number 33002789

Watch our “Part Testing” video to determine if the dryer igniter has burned out and needs to be replaced.

Ring bearing kit, front of dryer drum

Manufacturer Number 279441

Front tub glide bearing and seal assembly

Manufacturer Number 3406129

Front glide kit, (1) right (1) left glide (2) pads with adhesive backing and (1) cylinder support brace. Instructions included.

Manufacturer Number 12002126

Push to start switch

Manufacturer Number 3398095

If the dryer won't start check the thermal fuse on the blower housing first before ordering the start switch.The fuse is normally the problem if the dryer won't start.

Blower wheel

Manufacturer Number 56000

Light bulb

Manufacturer Number 67001316

Vent kit for close-quarter installations, 4" diameter

Manufacturer Number 4396013RB

Packaging includes 4-foot vent section that attaches to a close elbow, one 4-foot vent section that attaches to a wall offset, and an extension collar. Total length of this item is eight feet. Keep in mind that additional vents can be snapped between sections for longer runs.

Stacking Kit to stack the new Duet washer and dryer vertically, dryer over washer. May be installed in an enclosure if water supply faucets, electrical outlets and gas line connection (gas dryer only) are available. Installation instructions included.

Manufacturer Number 8541503

Door switch assembly

Manufacturer Number 3406105

Thermal fuse and high limit kit

Manufacturer Number W10480709

Front cover top retaining spring clip

Manufacturer Number 22001650

Blower wheel, 3-1/8” deep, 8” fin diameter, 7-1/8” hub diameter, 20 standard fins, ½” diameter motor shaft, 3/8” motor shaft diameter to flat side of shaft. Spring clamp not included.

Manufacturer Number 31001317

Screw

Manufacturer Number 489355

Thermistor

Manufacturer Number 35001191

Foam seal with adhesive backing

Manufacturer Number 339956

Kit, stack assembly

Manufacturer Number 8572546

Spray paint, white, 12 ounces

Manufacturer Number 350930

Screen, lint (white)

Manufacturer Number 8558467

Upper & lower air duct assembly with lint screen

Manufacturer Number 37001141

Shaft for drum support roller, left side

Manufacturer Number W10359270

Dryer blower wheel

Manufacturer Number 697772

Thermal fuse

Manufacturer Number 35001193

Blower housing housing foam seal with adhesive backing

Manufacturer Number 347139

Shaft for drum support roller, right side

Manufacturer Number W10359269

Screw

Manufacturer Number 308685

High limit thermostat, L225-40F

Manufacturer Number W10116735

Cycling thermostat, with internal-bias (heater) L155-25F

Manufacturer Number 8318268

Exhaust kit

Manufacturer Number W10470674

Dryer door seal. *Seal may come as one piece, hold at one end and pull apart to separate.

Manufacturer Number 31001529

Seal may come as one piece, hold at one end and pull apart to separate.