Estate Dryer Parts

Thermal fuse. If the dryer overheats, this device stops the flow of electricity to the heat source and/or the entire dryer. It is located on the blower housing and cannot be reset. The most common cause for overheating is a vent tube clogged with lint, a birds nest or other debris.

Manufacturer Number 3392519

Watch our “Part Testing” video to determine if the thermal fuse has blown out and needs to be replaced.

Dryer belt. This is the most common belt used on Whirlpool, Kenmore, Kitchenaid, Roper, Estate and other dryer brands. The belt is flat, 92-1/4 inches long, 1/4 inch wide and has 4 ribs and 3 grooves. It replaces many other belts, including some with 5 ribs and 4 grooves.

Manufacturer Number 341241

See our dryer belt diagram to see how this belt should be installed around the motor and idler pulleys.

Gas burner valve solenoids. Kit contains both the two wire and three wire solenoids. One solenoid is the primary and one is the safety. Both have to operate for the gas valve to open. Usually, one of them burns out but you should always replace them as a set.

Manufacturer Number 279834

These often fail intermittently, making diagnosis difficult. To test, watch the burner assembly while the dryer is heating. If the igniter glows for a while and then shuts off without the gas turning on, it usually means one of these coils is bad.

Dryer heating element. If your dryer does not heat, enter your model number into our Repair Help Section as this part is not the most common cause.

Manufacturer Number 279838

Normally, if you remove the old element a defective part will have a physical break in it. It can also be tested using a multimeter.See our Repair Help section for additional information

Igniter kit, will replace round or flat style, with bracket, wire nuts and mounting screw. Caution! The black heating element portion of this part is EXTREMELY fragile. Use caution when handling.

Manufacturer Number 279311

Watch our “Part Testing” video to determine if the dryer igniter has burned out and needs to be replaced.

Dryer cycling thermostat with internal bias heater, L155-25

Manufacturer Number 3387134

Door switch assembly

Manufacturer Number 3406107

Heating element thermal cut-off (thermal fuse) 309 degrees and high-limit thermostat 250 degrees, with wiring kit.

Manufacturer Number 279816

Watch our “Part Testing” video to determine if the thermal fuse has blown out and needs to be replaced.

Heating element thermal cut-off (thermal fuse) 360 degrees and high-limit thermostat 250 degrees.

Manufacturer Number 279769

Watch our “Part Testing” video to determine if the thermal fuse has blown out and needs to be replaced.

Heating element, 240 volts

Manufacturer Number 4391960

Watch our “Part Testing” video to determine if the dryer heating element has burned out and needs to be replaced.

Belt tension pulley

Manufacturer Number 691366

Rear drum support roller kit (2) in kit, Whirlpool-Kenmore, and others

Manufacturer Number 349241T

Plastic leveling leg

Manufacturer Number 49621

Universal door catch kit

Manufacturer Number 279570

Repair kit for Whirlpool, Kenmore, Roper dryer; rollers, belt and idler pulley, for 29" wide Dryers built 1965 and later

Manufacturer Number 4392065

Motor, dryer drum drive with pulley for belt

Manufacturer Number 279827

Lint filter, white

Manufacturer Number 8558463

Gas dryer sensor for igniter and flame

Manufacturer Number 338906

This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

LP conversion kit

Manufacturer Number 49572A

High-limit thermostat, L250-80, with terminal extension arm

Manufacturer Number 3977767

This thermostat should be closed for continuity at room temperature, opens at around 250 degrees Fahrenheit. Check for continuity with a multi-meter before replacing.

Tri-ring retainer for support roller

Manufacturer Number 690997

Light bulb, 10 watt

Manufacturer Number 22002263

Blower wheel

Manufacturer Number 694089

Timer, 60 hertz

Manufacturer Number W10185972

Dryer lint screen for most standard capacity dryers with pull-out lint screens, measures 17 5/8" x 7 1/8"

Manufacturer Number 339392

Rear felt seal with adhesive

Manufacturer Number 279857

White touch-up paint

Manufacturer Number 72017

Lint filter with handle, measures 20 3/4" x 7 1/2"

Manufacturer Number 349639

High-limit thermostat, 2 wire, 250 degree limit, 60 degree cool down before reset.

Manufacturer Number 3390291

Standard lid/door switch kit, 3-wire switch. Switch in kit is -multi purpose- for many appliance applications

Manufacturer Number 279347

Watch our “Part Testing” video to determine if the switch has failed and needs to be replaced.

Push to start switch

Manufacturer Number 3977456

Watch our “Part Testing” video to determine if the switch has failed and needs to be replaced.

Dryer vent cleaning brush. For 4" diameter round ducts. 20 feet long.

Manufacturer Number 18001034

Dryer door cable for spring item #3131

Manufacturer Number 230131

Front panel retainer clip, 1 per pack

Manufacturer Number 3394083

Motor pulley, 60 hertz

Manufacturer Number 8066184

Access panel retaining spring clip

Manufacturer Number 3388229

Top panel spring clip

Manufacturer Number 18776

Front tub glide bearing and seal assembly

Manufacturer Number 3406129

Push to start switch

Manufacturer Number 3398095

If the dryer won't start check the thermal fuse on the blower housing first before ordering the start switch.The fuse is normally the problem if the dryer won't start.

Ring bearing kit, front of dryer drum

Manufacturer Number 279441

Door switch assembly

Manufacturer Number 3406105

Push to start switch, 2 terminal

Manufacturer Number 3395382

Watch our “Part Testing” video to determine if the switch has failed and needs to be replaced.

Whirlpool/Kenmore Dryer Repair Manual, covers two and four roller gas or electric dryers

Manufacturer Number 787207L

Foam seal with adhesive backing

Manufacturer Number 339956

Thermal fuse and high limit kit

Manufacturer Number W10480709

Spray paint, white, 12 ounces

Manufacturer Number 350930

Screen, lint (white)

Manufacturer Number 8558467

Blower housing housing foam seal with adhesive backing

Manufacturer Number 347139

Dryer door/washer lid actuator spring steel for door switch

Manufacturer Number 691581

Screw

Manufacturer Number 308685

Adjustable dryer cycling thermostat kit L135-155

Manufacturer Number 694674

Shaft for drum support roller, left side

Manufacturer Number W10359270

Shaft for drum support roller, right side

Manufacturer Number W10359269

Door catch

Manufacturer Number 3389441

Push to start switch, 4 terminal

Manufacturer Number 3395385

Console screw

Manufacturer Number 388326

Dryer door spring, 1 per pack, cable is item #3112

Manufacturer Number 337186

Almond touch-up paint

Manufacturer Number 72107

Locking nut for leveling leg

Manufacturer Number 3359452

Screw, 10-24 3/8

Manufacturer Number 90767

Rear felt seal for most Whirlpool-Kenmore dryers

Manufacturer Number 239087

Dryer access panel clip, one per package

Manufacturer Number 297092

Touch-up paint, biscuit, .6 Fl. Oz.

Manufacturer Number 4392899

Timer assembly, 60 Hz.

Manufacturer Number W10185971

Push-to-start switch kit with brackets, hardware

Manufacturer Number 279173

Thrmst-fix

Manufacturer Number W10423382

Screw with plastic washer 8-18 x 1/2

Manufacturer Number 488729

Door switch assembly

Manufacturer Number 3406102

Gas valve leak limiter, Natural gas

Manufacturer Number 694424

Terminal block, power cord

Manufacturer Number 3397659

Clip, ground

Manufacturer Number 98234

Gas burner orifice, natural gas

Manufacturer Number 234826

Timer

Manufacturer Number W10185970

Door handle, white

Manufacturer Number 686711

Terminal connection and wire kit, main power

Manufacturer Number 279318

Screw, baffle mounting

Manufacturer Number W10109200

Dryer timer

Manufacturer Number 3979617

Heating element connection wire kit

Manufacturer Number 279457

Dryer access panel retaining clips and bumpers

Manufacturer Number 279638

Leveling leg, optional extended length (package of 2)

Manufacturer Number 279810

Dryer door seal/gasket

Manufacturer Number 3390733

Push to start switch

Manufacturer Number 3404233

Thermal cut-out (fuse)

Manufacturer Number 341196

Watch our “Part Testing” video to determine if the thermal fuse has overheated and needs to be replaced.

Dryer drum baffle

Manufacturer Number 692490

Terminal block kit for electric dryer power cord, includes instructions

Manufacturer Number 279320

High-limit dryer thermostat, L205-40

Manufacturer Number 279048

Door handle, white

Manufacturer Number 3405184

Drying rack for shoes and delicate items, fits Whirlpool 29 inch dryers with an "E" after the numbers in the model number and with dimples 4-1/2 inches apart in rear of dryer drum.

Manufacturer Number 3406839

Screw, 10-16 x 5/16"

Manufacturer Number 3390631

Temperature selector switch

Manufacturer Number 3399639

Stop, push-in

Manufacturer Number 357213

Console clip

Manufacturer Number 8312709

Gas valve assembly without burner tub

Manufacturer Number W10337269

Front felt bearing and felt seal kit with adhesive

Manufacturer Number 279264

Dryer door hinge, right side

Manufacturer Number 238456

Spring, clip knob

Manufacturer Number 8536939

Screw and nut kit, electric dryer cord connector.

Manufacturer Number 279393

Dryer timer assembly

Manufacturer Number 3976569

Dryer timer

Manufacturer Number 3976584