Jenn Air Dryer Parts

Dryer belt. This is the most common belt used on Whirlpool, Kenmore, Kitchenaid, Roper, Estate and other dryer brands. The belt is flat, 92-1/4 inches long, 1/4 inch wide and has 4 ribs and 3 grooves. It replaces many other belts, including some with 5 ribs and 4 grooves.

Manufacturer Number 341241

See our dryer belt diagram to see how this belt should be installed around the motor and idler pulleys.

Gas burner valve solenoids. Kit contains both the two wire and three wire solenoids. One solenoid is the primary and one is the safety. Both have to operate for the gas valve to open. Usually, one of them burns out but you should always replace them as a set.

Manufacturer Number 279834

These often fail intermittently, making diagnosis difficult. To test, watch the burner assembly while the dryer is heating. If the igniter glows for a while and then shuts off without the gas turning on, it usually means one of these coils is bad.

Thermal fuse, high-limit thermostat kit for gas/electric dryer

Manufacturer Number LA-1053

Watch our “Part Testing” video to determine if the thermal fuse has overheated and needs to be replaced.

Gas dryer sensor for igniter and flame

Manufacturer Number 338906

This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Blower wheel retaining ring

Manufacturer Number 25-7855

Lint filter

Manufacturer Number 53-0918

Door catch kit, includes catch and clip (metal)

Manufacturer Number LA-1003

Drum support roller kit with axles and mounting screws. Kit has been updated it has 1 plastic spacer that is the thickness of 2 spacers.

Manufacturer Number LA-1008

Heating element assembly with replacement high limit thermostat, L248-80 (240 Volt-4750 Watt)

Manufacturer Number LA-1044

Watch our “Part Testing” video to determine if the dryer heating element has burned out and needs to be replaced.

Blower wheel clamp

Manufacturer Number 312967

Front glide kit, (1) right (1) left glide (2) pads with adhesive backing and (1) cylinder support brace. Instructions included.

Manufacturer Number 12002126

Blower wheel, 3-1/8” deep, 8” fin diameter, 7-1/8” hub diameter, 20 standard fins, ½” diameter motor shaft, 3/8” motor shaft diameter to flat side of shaft. Spring clamp not included.

Manufacturer Number 31001317

Blower wheel, 3-1/8” deep, 8” fin diameter, 7-1/8” hub diameter, 20 standard fins, ½” diameter motor shaft, 7/16” motor shaft diameter to flat side of shaft. Spring clamp not included. Series B10 only

Manufacturer Number 31001043

Dryer door seal. *Seal may come as one piece, hold at one end and pull apart to separate.

Manufacturer Number 31001529

Seal may come as one piece, hold at one end and pull apart to separate.