Maytag Parts

Thermal fuse. If the dryer overheats, this device stops the flow of electricity to the heat source and/or the entire dryer. It is located on the blower housing and cannot be reset. The most common cause for overheating is a vent tube clogged with lint, a birds nest or other debris.

Manufacturer Number 3392519

Watch our “Part Testing” video to determine if the thermal fuse has blown out and needs to be replaced.

Drive motor coupler. New style with metal sleeves for added strength. This version replaces all previous motor coupler styles and versions. For direct drive washing machines.

Manufacturer Number 285753A

Common symptom of failed coupler is washer will fill, not agitate or spin but will drain the water from the tub.

Dryer belt. This is the most common belt used on Whirlpool, Kenmore, Kitchenaid, Roper, Estate and other dryer brands. The belt is flat, 92-1/4 inches long, 1/4 inch wide and has 4 ribs and 3 grooves. It replaces many other belts, including some with 5 ribs and 4 grooves.

Manufacturer Number 341241

See our dryer belt diagram to see how this belt should be installed around the motor and idler pulleys.

Gas burner valve solenoids. Kit contains both the two wire and three wire solenoids. One solenoid is the primary and one is the safety. Both have to operate for the gas valve to open. Usually, one of them burns out but you should always replace them as a set.

Manufacturer Number 279834

These often fail intermittently, making diagnosis difficult. To test, watch the burner assembly while the dryer is heating. If the igniter glows for a while and then shuts off without the gas turning on, it usually means one of these coils is bad.

Dryer heating element. If your dryer does not heat, enter your model number into our Repair Help Section as this part is not the most common cause.

Manufacturer Number 279838

Normally, if you remove the old element a defective part will have a physical break in it. It can also be tested using a multimeter.See our Repair Help section for additional information

Washing machine agitator repair kit with a medium length cam (there are other kits available for different models). This kit should be used when the top part of the agitator is not moving properly but the bottom part is.

Manufacturer Number 285811

Drain pump for belt-less direct-drive washer, one large port, one small port.

Manufacturer Number 3363394

Mounts directly to the motor with two clips. A leaking pump may cause a small puddle in the front of the washer.

Drum support roller with bearing

Manufacturer Number 12001541

Both rollers should be replaced at the same time

Lower dishrack front roller and axle assembly, clip on

Manufacturer Number WD12X271

Chrome drip bowl for 6" burner, electric range

Manufacturer Number W10196406RW

Spanner nut wrench for MOST Whirlpool/Kenmore, General Electric & Maytag inner tub lock nuts

Manufacturer Number TB123A

Maytag/Amana/Jenn-Air PuriClean II Refrigerator Water Filter - The PuriClean II water filter is manufacturer part number UKF8001AXX. It is a high-quality carbon filter that reduces contaminants such as lead, cysts, pesticides, herbicides and much more. Replace annually or when the filter light is on

Manufacturer Number UKF8001

Dishwasher door latch and handle assembly complete, black

Manufacturer Number W10130695

Manufacturer specified oven and broiler igniter kit, replaces short and longer igniters in many instances. Amperage range 3.3 - 3.6

Manufacturer Number 12400035

Links, door balance

Manufacturer Number 8194001

Igniter kit, will replace round or flat style, with bracket, wire nuts and mounting screw. Caution! The black heating element portion of this part is EXTREMELY fragile. Use caution when handling.

Manufacturer Number 279311

Watch our “Part Testing” video to determine if the dryer igniter has burned out and needs to be replaced.

Chrome drip bowl for 8" burner, electric range

Manufacturer Number W10196405

Drum support roller

Manufacturer Number 37001042

Washing Machine agitator repair kit. *Short cam.

Manufacturer Number 285809

The teeth on the dog ears often wear out and cause the top of the agitator to not work properly.

Washing machine water inlet valve kit, with bracket

Manufacturer Number 285805

A long or slow fill cycle is often due to a restricted water valve. The valve should never be disassembled and cleaned, only replaced.

Door-key

Manufacturer Number DE64-01308A

Silverware basket **Picture is a redesign of part. Part sent may be the original style and look different**

Manufacturer Number 6-918873

Dryer belt, length 93 3/8”, width 3/8”, characteristics, 5 ridges, flat

Manufacturer Number 40111201

Door switch assembly

Manufacturer Number 3406107

Dryer cycling thermostat with internal bias heater, L155-25

Manufacturer Number 3387134

Belt, dryer drum drive

Manufacturer Number Y312959

Washing machine clutch assembly with hardware. *Blue spring for large capacity washers, black for compacts.

Manufacturer Number 285785

A worn clutch often causes a slower spin speed which leaves the clothes soaked after the cycle.

Heating element thermal cut-off (thermal fuse) 309 degrees and high-limit thermostat 250 degrees, with wiring kit.

Manufacturer Number 279816

Watch our “Part Testing” video to determine if the thermal fuse has blown out and needs to be replaced.

Whirlpool water filter by PUR for the EZ Change Advanced system. Reduces 6 contaminents, including lead, mercury, chlorine, benzene and more. This filter does not reduce Fluoride which is often added to drinking water to promote healthy teeth. This filter is recommended for Fast-Fill refrigerators.

Manufacturer Number 4396841

No need to turn off the water supply to change this filter. Simply remove this one and replace with the new filter according to the instructions.

Suspension spring

Manufacturer Number 63907

A bad or broken suspension spring causes tub balancing problems during the spin cycle.

Replacement 8 cube icemaker kit, replaces many Whirlpool-made ice makers. Does not include shut off arm.

Manufacturer Number 4317943

You remove the shut off arm from the old icemaker lift it to the up position, unhook it from the fill cup bearing, and pull it out of the module.

Heating element thermal cut-off (thermal fuse) 360 degrees and high-limit thermostat 250 degrees.

Manufacturer Number 279769

Watch our “Part Testing” video to determine if the thermal fuse has blown out and needs to be replaced.

Dishrack roller kit,set of 4

Manufacturer Number WD12X10327

Dishwasher door latch and handle assembly complete, white

Manufacturer Number W10130694

Heating element assembly, 240 volts

Manufacturer Number 3387747

Watch our “Part Testing” video to determine if the dryer heating element has burned out and needs to be replaced.

Lightbulb cover lens, snap in.

Manufacturer Number S99110437

Light bulb, 125V/30W

Manufacturer Number 6912W1Z004B

Crisper pan

Manufacturer Number 2188656

Dryer thermistor assembly

Manufacturer Number 8577274

The thermistor should read approximately 11.9K Ohms of resistance at 21 degrees Celsius (70 degrees Fahrenheit).

Door bin

Manufacturer Number 2187172

40 watt frosted light bulb

Manufacturer Number 8009

Bracket, upper mounting

Manufacturer Number 8269145

Icemaker assembly, For in-door ice models. *Remove bottom bracket from old icemaker and reattach it to the new icemaker.

Manufacturer Number 2198597

Chrome drip bowl for 8 inch burner, Jenn Air electric range

Manufacturer Number 715878

Dishrack lower wheel assembly. Integrated clip-on axle. Light gray.

Manufacturer Number 99003149

Drum glide pad (Replace in Pairs)

Manufacturer Number 37001298

Charcoal filter

Manufacturer Number 8206230A

Belt tension pulley

Manufacturer Number 691366

Plastic leveling leg

Manufacturer Number 49621