Montgomery Wards Parts

Dryer belt. This is the most common belt used on Whirlpool, Kenmore, Kitchenaid, Roper, Estate and other dryer brands. The belt is flat, 92-1/4 inches long, 1/4 inch wide and has 4 ribs and 3 grooves. It replaces many other belts, including some with 5 ribs and 4 grooves.

Manufacturer Number 341241

See our dryer belt diagram to see how this belt should be installed around the motor and idler pulleys.

Gas burner valve solenoids. Kit contains both the two wire and three wire solenoids. One solenoid is the primary and one is the safety. Both have to operate for the gas valve to open. Usually, one of them burns out but you should always replace them as a set.

Manufacturer Number 279834

These often fail intermittently, making diagnosis difficult. To test, watch the burner assembly while the dryer is heating. If the igniter glows for a while and then shuts off without the gas turning on, it usually means one of these coils is bad.

Oven bake heating element, push-on wire connectors.

Manufacturer Number 316075104

Watch our “Part Testing” video to determine if the bake or broil element has burned out and needs to be replaced.

Dishrack roller and axle assembly, clip on. Lower rack, front.

Manufacturer Number WD12X271

Rear dryer drum bearing kit

Manufacturer Number 5303281153

Surface burner terminal block kit with interchangeable mounting brackets, ceramic wire nuts, heat shrink protective tubing and wires. Will work in many different stove brands.

Manufacturer Number 5303935058

Oven igniter assembly, short ceramic, with bracket and wires, overall length is 3.72", amperage range 3.2 - 3.6

Manufacturer Number 5303935066

Dishrack roller kit, includes 4

Manufacturer Number WD12X10327

Manufacturer specified oven and broiler igniter kit, replaces short and longer igniters in many instances. Amperage range 3.3 - 3.6

Manufacturer Number 12400035

Blower wheel retaining ring

Manufacturer Number 25-7855

Icemaker replacement, modular style, no cover, shut-off arm or wire harness, reuse from original icemaker

Manufacturer Number D7824706Q

Utility oven drawer glide, front

Manufacturer Number 3051162

Gas dryer sensor for igniter and flame

Manufacturer Number 338906

This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Oven bake heating element with push-on wire terminals

Manufacturer Number 74003019

Watch our “Part Testing” video to determine if the bake or broil element has burned out and needs to be replaced.