GO
SEARCH:
Back

Fault Codes

Dacor Range/Stove/Oven

Failure
Code
Condition
Check/Repair
F0 Clock pushbutton is stuck in a depressed position Check clock buttons
F1 Element relay circuit failure Control board may be bad
F2 Oven temperature exceeded the clean runaway temperature (self clean only) or the cooking runaway temperature (cooking modes only) Call for service
F3 Short Circuit in the oven temperature sensor Check oven temperature sensor for continuity, if no resistance (zero ohms), replace
F4 Short Circuit in the oven temperature sensor Check oven temperature sensor for continuity, if no resistance (zero ohms), replace
F6 Failure in the EEPROM check comparison (only time of day and timer will operate) Call for service, electronic clock control is usually the cause of the problem
F7 Failure of the self- clean automatic door latch system Check door latch and switch(es)
F8 Failure of the door latch motor. Occurs when the motor runs for two minutes without the door locking in self-clean mode Check door lock motor and door latch