Get Repair Help

Shop for Parts

Enter your part or model number for best results

Maytag Type "C" and "D" Clocks Range/Stove/Oven Fault Codes

Failure Code	Condition	Check/Repair
F1	Supervisory relay enable shorted (non-cook mode); sounds alarm and inhibits cook mode if alarm fault monitor is always active in non-cook mode, and requires removal of power until serviced.	Usually a bad touch pad or clock assembly (also called the ERC). Replace touchpad or ERC
F2	Bake/broil/clean temp runaway alarm; sounds alarm and resets control to non-cook mode when bake/broil/clean temp exceeds programmed limits.	Usually means a stuck relay. Electric @ 525F (bake), 640F(broil), 900F(clean) Gas @ 525F (bake), 640F(broil), 900F(clean)
F3	Open temp oven temperature sensor; sounds alarm and inhibits cook mode	Replace oven temperature sensor
F4	Shorted temp oven temperature sensor; sounds alarm and inhibits cook mode	Replace oven temperature sensor
F5	Supervisory relay enable open (cook mode); sounds alarm and resets the control to non-cook mode	Replace electronic range control (ERC)
F5	Missing a/c line cycle detector; displays code (no audible)	Unplug appliance for two minutes, should clear problem
F7	Function key shorted; too hot at the clock assembly (also called the ERC) or shorted touch pad or clock assembly (also called the ERC)	Replace touchpad or ERC
F8	Analog/Digital supervisory; sounds alarm to non-cook mode	Replace ERC
F9	Door latch supervisory (door latched)	Unlock door and check switches or clock assembly (also called the ERC)
F0	Cancel key supervision	Requires the removal of power until serviced. See qualified technician