Enter Part or Model Number for best results

(Where is my model number?)
Back
Got a Thumping Noise?
You Can Do It

Fault Codes

Roper Range/Stove/Oven

NOTE: Not valid for Y line. If there is a Y near the end of your model number, do not use this chart.

Failure
Code
Condition
Check/Repair
4 Digit Failure Code
F0 - E0
Analog to Digital Failure
Disconnect for 30 seconds - if display re-appears - replace control
F1 - E1
Safety flip flop
Replace Electronic Range Control/Clock (ERC)
F2 - E0
Shorted keypad
Replace Electronic Range Control/Clock (ERC)
F3 - E0
Oven temperature sensor or oven temperature sensor fuse opened
Replace oven temperature sensor or fuse
F3 - E1
Oven temperature sensor shorted
Replace oven temperature sensor
F3 - E2
Oven too hot
Replace oven temperature sensor
F3 - E3
Clean temp too hot
Replace oven temperature sensor
F5 - E0
F5 - E1 and E2
Door latch problem
Check door/latch switch, replace if necessary
2 Digit Failure Code
F0 or F1 or F5
Failed Electronic Range Control (ERC)
Replace Electronic Range Control/Clock (ERC)
F2 - E0
Oven temp too high
1. Test operation of door lock on self-clean models
2. Test relay contact operation
3. High resistance in oven temperature sensor
F3
Open oven temperature sensor or thermal fuse, bad oven temperature sensor harness, or oven temperature sensor resistance too high
Replace oven temperature sensor or thermal fuse
F4
Shorted oven temperature sensor
Replace oven temperature sensor
F6
Problem in time keeping circuit
1. Reset time and/or cooking operation
2.
Check for proper ground
F7
Stuck function switch or button on Electronic Range Control (ERC)
Replace Electronic Range Control/Clock (ERC)
F8
Failure of Electronic Range Control (ERC)
Replace Electronic Range Control/Clock (ERC)
F9
Door lock circuit
Check wiring and test operation of door lock switch
DOOR
Bake or Broil
· Defective latch switch
· Shorted wire from ERC 10-pin connector, pin 10 to ground
· Door latched
Replace latch switch if defective.Replace wire from 10-pin connector if defective
DOOR
Self-Clean
· Defective latch switch
· Open wire from ERC 10-pin connector, pin 10 to ground
· Door not latched
Replace latch switch if defective.Replace wire from 10-pin connector if defective
LOCK
Not in Self-Clean
· Oven temperature sensor resistance too high
Check oven temperature sensor resistance, wire harness and connections, replace defective component