Get Repair Help

Shop for Parts

Enter your part or model number for best results

Fault Codes

Roper Range/Stove/Oven

NOTE: Not valid for Y line. If there is a Y near the end of your model number, do not use this chart.

Failure Code	Condition	Check/Repair
4 Digit Failure Code
F0 - E0	Analog to Digital Failure	Disconnect for 30 seconds - if display re-appears - replace control
F1 - E1	Safety flip flop	Replace Electronic Range Control/Clock (ERC)
F2 - E0	Shorted keypad	Replace Electronic Range Control/Clock (ERC)
F3 - E0	Oven temperature sensor or oven temperature sensor fuse opened	Replace oven temperature sensor or fuse
F3 - E1	Oven temperature sensor shorted	Replace oven temperature sensor
F3 - E2	Oven too hot	Replace oven temperature sensor
F3 - E3	Clean temp too hot	Replace oven temperature sensor
F5 - E0 F5 - E1 and E2	Door latch problem	Check door/latch switch, replace if necessary
2 Digit Failure Code
F0 or F1 or F5	Failed Electronic Range Control (ERC)	Replace Electronic Range Control/Clock (ERC)
F2 - E0	Oven temp too high	1. Test operation of door lock on self-clean models 2. Test relay contact operation 3. High resistance in oven temperature sensor
F3	Open oven temperature sensor or thermal fuse, bad oven temperature sensor harness, or oven temperature sensor resistance too high	Replace oven temperature sensor or thermal fuse
F4	Shorted oven temperature sensor	Replace oven temperature sensor
F6	Problem in time keeping circuit	1. Reset time and/or cooking operation 2. Check for proper ground
F7	Stuck function switch or button on Electronic Range Control (ERC)	Replace Electronic Range Control/Clock (ERC)
F8	Failure of Electronic Range Control (ERC)	Replace Electronic Range Control/Clock (ERC)
F9	Door lock circuit	Check wiring and test operation of door lock switch
DOOR	Bake or Broil · Defective latch switch · Shorted wire from ERC 10-pin connector, pin 10 to ground · Door latched	Replace latch switch if defective.Replace wire from 10-pin connector if defective
DOOR	Self-Clean · Defective latch switch · Open wire from ERC 10-pin connector, pin 10 to ground · Door not latched	Replace latch switch if defective.Replace wire from 10-pin connector if defective
LOCK	Not in Self-Clean · Oven temperature sensor resistance too high	Check oven temperature sensor resistance, wire harness and connections, replace defective component