GO
SEARCH:
Back

Fault Codes

Roper Range/Stove Oven BES-BEP models

Failure
Code
Condition
Check/Repair
F2
Bake/Clean temperature runaway alarm
1. Allow unit to sit for one hour to cool down
2. Place oven temperature sensor in a glass of ice water
3. Measure oven temperature sensor resistance. The oven temperature sensor should measure about 1000 ohms while in the ice water
· If the oven temperature sensor is good but the problem remains replace the electronic range control (ERC)
· If the oven temperature sensor is bad, replace it.
F3
Oven temperature sensor circuit open
Verify the oven temperature sensor wiring harness is OK, if so, replace the oven temperature sensor.
F4
Shorted oven temperature sensor circuit
Verify the oven temperature sensor wiring harness is OK, if so, replace the oven temperature sensor.
F5
Element relay enable on. (STUCK CLOSED)
Replace the electronic range control (ERC)
F6
Power was interrupted
Push the OFF/CANCEL button
F8
Improper door lock points
1. Check the door latch switch
2. Check the 8-pin connector on the control for a good connection

Replace the electronic range control (ERC) if the connections and latch switch check out OK.