Enter Part or Model Number for best results

(Where is my model number?)
Back
Got a Thumping Noise?
You Can Do It

Fault Codes

Thermador Range/Stove/Oven Fault Codes starting with an E


If an error code appears in the cook mode window
Your oven is equipped with an extremely reliable and accurate electronic control. On the rare occasion that something occurs that causes a malfunction, an error message will appear in the oven selector window.

Some errors (E1, E9, E11, E12, and E13) must be cleared by turning off the oven at the circuit breaker and then turning it back on. When an error remains displayed steadily in the off position, after attempting to clear the error, a service call is required.

Have the error code available when you call for service. This will help service determine the problem.

Error
Code
Notes
Check/Repair
E1
C, E
Control board problem
E2
K, G
Cook or clean mode runaway
E3
A, H
Open oven temperature sensor (over 5000 ohms)
E4
A, H
Shorted oven temperature sensor (under 500 ohms)
E5
K, D
Control board too cold or too hot, or defective board.
E6
C, J
Control board problem
E7
A, I
Illegal temp display turn off and retry
E8
A, D
Control board problem
E9
A, E
Latch switch problems
E10
B, D
Control board problem
E11
A, F
CT oven; latch switch problem
E12
A, E
CT oven; latch switch problem
E13
A, C
CT ovens; latch froze or no power to latch motor

CMT ovens; control board not converted
E14
A, E
Latch switch problems
E15
B, D
Control board problem
Notes
A
Turns heat off on failed oven only, micro not affected
B
Turns all heat off, micro not affected
C
Disables clean mode in both ovens, allows cook and microwave
D
Error will remain in display until repaired and powered up. No error tones
E
1. Turn the clock selector knob to OFF
2. “Tweak” the oven control by turning the clock selector knob slightly to the left (counter clockwise). This may stop the flashing message/beeping and clear the display window.
F
Tweaking clears to "---" for retry
G
Clears when oven temp drops below runaway temp and selector is off
H
Can be cancelled by tweaking if a good oven temperature sensor is detected
I
Cleared with a mode change
J
Can be tweaked away for retry. User must unlatch and delete the "---" to try to relatch the door
K
Turns all heat and micro off
L
If two switches show locked door, then "E13" and "Lock" are permanent in display (all modes). If two switches show an open door you can tweak away the "E13"