GO
SEARCH:
Back

Fault Codes

Whirlpool Range/Stove/Oven Fault Codes Non Y-Line

NOTE: Not valid for Y line. If there is a Y near the end of your model number, do not use this chart.

Failure
Code
Condition
Check/Repair
4 Digit Failure Code
F0 - E0
Analog to Digital Failure
Disconnect for 30 seconds - if display re-appears - replace control
F1 - E1
Safety flip flop
Replace Electronic Range Control/Clock (ERC)
F2 - E0
Shorted keypad
Replace Electronic Range Control/Clock (ERC)
F3 - E0
Oven temperature sensor or oven temperature sensor fuse opened
Replace oven temperature sensor or fuse
F3 - E1
Oven temperature sensor shorted
Replace oven temperature sensor
F3 - E2
Oven too hot
Replace oven temperature sensor
F3 - E3
Clean temp too hot
Replace oven temperature sensor
F5 - E0 F5 - E1 and E2
Check door/latch switch
Replace component
2 Digit Failure Code
F0 or F1 or F5
Failed transistor
Replace Electronic Range Control/Clock (ERC)
F2 - E0
Oven temp too high
1. Test operation of door lock on self-clean models
2. Test relay contact operation
3. High resistance in oven temperature sensor
F3
Open oven temperature sensor or thermal fuse
Replace oven temperature sensor or thermal fuse
F4
Shorted oven temperature sensor
Replace oven temperature sensor
F6
Problem in time keeping circuit
1. Reset time and/or cooking operation
2. Check for proper ground
F7
Stuck function switch or button on Electronic Range Control (ERC)
Replace ERC (Electronic Range Control/Clock)
F8
Failure Electronic Range Control (ERC)
Replace ERC (Electronic Range Control/Clock)
F9
Door lock circuit
Check wiring and test operation of door lock switch