Enter Part or Model Number for best results

(Where is my model number?)
Back
Got a Thumping Noise?
You Can Do It

Fault Codes

Whirlpool Calypso Matching Dryer

Failure
Code
Condition
Check/Repair
PF
Power Failure
If the household power goes off and the control board was in RUN mode or PAUSE mode, the electronic control board will display a power failure error code.
E1 or E2
Thermistor Failure
The dryer will not operate if the exhaust temperature drops below 18 degrees F. or exceeds 250 degrees F.

When the thermistor circuit is open (>50K ohms), the error code E1 flashes in the display.

When the thermistor circuit is shorted (<500 ohms), the error code E2 flashes in the display.

Normal thermistor resistance values:
60 degrees F. - 15.3K ohms.
70 degrees F. - 11.9K ohms.
80 degrees F. - 9.2K ohms.
E3
Touchpad or Software mismatch
Flashes when there is a touchpad or software mismatch. NOTE: This error code is displayed only in diagnostics mode.