GO
SEARCH:

KitchenAid Dishwasher Won't Fill

KUDC10FXSS1

The 4 most common part(s) or condition(s) which cause the symptom Dishwasher won't fill are listed below starting with the most likely. Check or test each item and watch any available videos.

Grid is 1 inch square
Water Inlet Valve - Part # 3015511 Mfg Part # W10327249

Water Inlet Valve

RepairClinic Item # 3015511

The dishwasher has an electrical water valve called a water inlet valve. If the dishwasher won't fill with water, the water inlet valve might be defective. These valves are not repairable and will have to be replaced.

$51.35

Order by 8:00 PM ET, this part ships TODAY!

Add to Cart

365 Day Return Policy

Grid is 1 inch square
Float - Part # 1872050 Mfg Part # W10195036

Float

RepairClinic Item # 1872050

The float assembly is normally inside the dishwasher near the door on the floor of the dishwasher. If something gets stuck underneath it and holds the float assembly up, the dishwasher won't fill with water. If the float assembly moves freely up and down, the float switch might be defective.

$32.40

Order by 8:00 PM ET, this part ships TODAY!

Add to Cart

365 Day Return Policy

Grid is 1 inch square
Float Switch - Part # 1872053 Mfg Part # W10195039

Float Switch

RepairClinic Item # 1872053

The float switch is actuated by the float assembly. It is a protection device designed to prevent the dishwasher from overfilling. If the dishwasher won't fill with water, it may be because this float switch is defective or stuck.

$25.00

Order by 8:00 PM ET, this part ships TODAY!

Add to Cart

365 Day Return Policy

Other Causes and Conditions

Water Supply Problem

The dishwasher is connected to the hot water supply from the house. Check to be sure the household water supply valve is turned on. Over time, calcium deposits can build up in the water supply valve or in the small filter screen inside the water inlet valve. The water supply line may need to be removed from the water inlet valve of the dishwasher, then run some water into a bucket to see if there is enough pressure. Be certain to turn off the water before working on the water line.

Back to Symptom List