Enter Part or Model Number for best results

(Where is my model number?)

LG Dryer Stops Turning During Cycle

DLE2050W

The 3 most common part(s) or condition(s) which contribute to the symptom Dryer stops turning during cycle are listed below. Check or test each item and watch any available videos. If you are still unable to solve the problem you may need to do additional research and troubleshooting. Remember, with our 365 Days. Period.® return policy you can return any part for any reason. So, go ahead and buy it to try it. No other parts retailer offers this unconditional return policy.

For the symptom you selected, these are the most common parts or causes, ordered by the likelihood of fixing the symptom.

Grid is 1 inch square
Drive Motor - Part # 1330330 Mfg Part # 4681EL1008A

Drive Motor

RepairClinic Item # 1330330

The dryer drive motor turns the drum and the blower wheel to exhaust the air. If the dryer stops the motor might be defective. If the dryer stops and the dryer motor makes a humming noise there might be something caught in the blower wheel, or the drum might be binding. Try removing the belt from the motor and checking the blower wheel for obstructions. Also try rotating the drum by hand with the belt off, it should rotate freely. If the drum doesn't turn freely, determine what is causing it to bind. The dryer motor can't be tested easily. If the drum turns freely and the blower wheel is clear, and yet the dryer still keeps stopping mid-cycle the motor may be defective. it will need to be replaced. It is not serviceable.

Place your order by 8:00 PM ET and this item will ship out today - or it's FREE!

$129.50

Grid is 1 inch square
Drum Roller - Part # 2700894 Mfg Part # 4581EL3001E

Drum Roller

RepairClinic Item # 2700894

This dryer has drum support rollers. There will always be two supporting the rear of the drum, and on some models there may be two supporting the front of the drum. The rollers must spin freely to work properly. If they are worn out or start binding the motor can get overloaded and the dryer stops. If the dryer stops mid-cycle, check to be sure the drum turns freely with the belt removed. If not, check the rollers. Do not lubricate the rollers or roller shaft, lubrication will attract lint and cause the roller bearings to wear out faster. If the rollers don't turn freely, replace them. The roller shaft can often be reused, unless it has worn down. Clean the shaft thoroughly before installing the new rollers.

Place your order by 8:00 PM ET and this item will ship out today - or it's FREE!

$9.25

Grid is 1 inch square
Drum Support Roller & Axle - Part # 2701044 Mfg Part # 4581EL2002C

Drum Support Roller & Axle

RepairClinic Item # 2701044

This dryer has drum support rollers.There will always be two supporting the rear of the drum and on some models there may be two supporting the front of the drum. The rollers must spin freely to work properly. If the roller axles are worn out the rollers may not spin freely. If not, check the rollers and rollers shafts. If they are worn or do not turn freely they will need to be replaced.

Place your order by 8:00 PM ET and this item will ship out today - or it's FREE!

$20.80

Back to Symptom List