GO
SEARCH:

Amana Oven Broiler Problem

ARG7102W

The 5 most common part(s) or condition(s) which cause the symptom Oven broiler problem are listed below starting with the most likely. Check or test each item and watch any available videos.

Grid is 1 inch square
Oven Igniter - Part # 1191 Mfg Part # 786324

Oven Igniter

RepairClinic Item # 1191

Even though the oven igniter may be glowing, it may be too weak to allow the gas valve to open. If the oven broiler igniter glows for more than 90 seconds without igniting the gas flame, the oven broil igniter should be replaced. This is the most common part that fails when there is an oven broiler problem.

$52.70

Order by 8:00 PM ET, this part ships TODAY!

Add to Cart

365 Day Return Policy

Grid is 1 inch square
Oven Igniter - Part # 793357 Mfg Part # 31940001

Oven Igniter

RepairClinic Item # 793357

Even though the oven igniter may be glowing, it may be too weak to allow the gas valve to open. If the oven broiler igniter glows for more than 90 seconds without igniting the gas flame, the oven broil igniter should be replaced. This is the most common part that fails when there is an oven broiler problem.

$43.10

Order by 8:00 PM ET, this part ships TODAY!

Add to Cart

365 Day Return Policy

Other Causes and Conditions

Loose or Burnt Wire Connection

If there is an oven broiler problem, there might be a burnt wire supplying power to the broil element. Sometimes the wire supplying power to the element burns out right near the element itself. Check for this by just looking at the wires leading to the element. If they're burned out it is usually easy to spot.

Grid is 1 inch square
Oven Control Board - Part # 503000 Mfg Part # 31864501

Oven Control Board

RepairClinic Item # 503000

The oven control board has a set of relays that turn on and off power to the bake and broil circuits according to the customer settings and sensor input. An oven broiler problem is usually caused by one of the heating components. However, if the oven control board is bad, it might not send voltage to the heating components. To determine what is causing the oven broiler problem, first test the simpler components in the circuit. The oven control board can't be tested easily and will have to be replaced if it is defective.

$238.95

Order by 8:00 PM ET, this part ships TODAY!

Add to Cart

365 Day Return Policy

Grid is 1 inch square
Oven Safety Valve - Part # 1242180 Mfg Part # Y0316220

Oven Safety Valve

RepairClinic Item # 1242180

The oven saftey valve is in series with the broiler igniter. When the broil igniter is on it draws current thru the valve . When the proper current draw is met the valve will open and let the gas thru. Saftey valves do not go out often. The igniter is more likely the problem. If the igniter is weak it will glow but not draw enough current to open the valve and will have to be replaced. Do not put 110 volts to the valve it will blow out the valve and it will have to be replaced.

$127.40

Order by 8:00 PM ET, this part ships TODAY!

Add to Cart

365 Day Return Policy

Back to Symptom List