GO
SEARCH:

Jenn Air Oven Self Cleaning Problem

JES8850AAB

The 3 most common part(s) or condition(s) which cause the symptom Oven self cleaning problem are listed below starting with the most likely. Check or test each item and watch any available videos.

Grid is 1 inch square
Door Lock Motor and Switch Assembly - Part # 895061 Mfg Part # 74005675

Door Lock Motor and Switch Assembly

RepairClinic Item # 895061

For an oven self cleaning problem, the first thing to check is the door lock motor and switch assembly. Every self cleaning oven door has a locking mechanism to prevent the door from being opened during the cleaning cycle. An oven self cleaning problem often happens after a clean cycle has been run. If that happens, help may be needed to help figure out how to repair or replace the door lock motor and switch assembly because often the door is locked in the closed position. Manufacturers normally design the lock mechanism so that the door can be opened by removing certain screws or panels.

Grid is 1 inch square
Oven Control Board - Part # 1009029 Mfg Part # 74007221

Oven Control Board

RepairClinic Item # 1009029

The oven control board has a set of relays that turn on and off power to the bake and broil circuits according to the customer settings and sensor input. An oven self-cleaning problem is sometimes caused by one of the heating components. However, if the oven control board is bad, it might not send voltage to the heating components. To determine what is causing the oven self-cleaning problem, first test the simpler components in the circuit. The oven control board can't be tested easily and will have to be replaced if it is defective.

Picture Unavailable

Oven Control Board

RepairClinic Item # 1035540

The oven control board has a set of relays that turn on and off power to the bake and broil circuits according to the customer settings and sensor input. An oven self-cleaning problem is sometimes caused by one of the heating components. However, if the oven control board is bad, it might not send voltage to the heating components. To determine what is causing the oven self-cleaning problem, first test the simpler components in the circuit. The oven control board can't be tested easily and will have to be replaced if it is defective.

Back to Symptom List