Enter Part or Model Number for best results

(Where is my model number?)

KitchenAid Oven Self Cleaning Problem


The 3 most common part(s) or condition(s) which contribute to the symptom Oven self cleaning problem are listed below. Check or test each item and watch any available videos. If you are still unable to solve the problem you may need to do additional research and troubleshooting. Remember, with our 365 Days. Period.® return policy you can return any part for any reason. So, go ahead and buy it to try it. No other parts retailer offers this unconditional return policy.

For the symptom you selected, these are the most common parts or causes, ordered by the likelihood of fixing the symptom.

Grid is 1 inch square
Door Lock Motor and Switch Assembly - Part # 1547132 Mfg Part # W10195934

Door Lock Motor and Switch Assembly

RepairClinic Item # 1547132

For an oven self cleaning problem, the first thing to check is the door lock motor and switch assembly. Every self cleaning oven door has a locking mechanism to prevent the door from being opened during the cleaning cycle. An oven self cleaning problem often happens after a clean cycle has been run. If that happens, help may be needed to help figure out how to repair or replace the door lock motor and switch assembly because often the door is locked in the closed position. Manufacturers normally design the lock mechanism so that the door can be opened by removing certain screws or panels.

Place your order by 8:00 PM ET and this item will ship out today - or it's FREE!


Grid is 1 inch square
Oven Control Board - Part # 1201919 Mfg Part # 9762794

Oven Control Board

RepairClinic Item # 1201919

The oven control board has a set of relays that turn on and off power to the bake and broil circuits according to the customer settings and sensor input. An oven self-cleaning problem is sometimes caused by one of the heating components. However, if the oven control board is bad, it might not send voltage to the heating components. To determine what is causing the oven self-cleaning problem, first test the simpler components in the circuit. The oven control board can't be tested easily and will have to be replaced if it is defective.

Grid is 1 inch square
Thermal Fuse - Part # 1061375 Mfg Part # 9759242

Thermal Fuse

RepairClinic Item # 1061375

Although not as common, with an oven self cleaning problem the thermal fuse may have blown. The thermal fuse is designed to protect the appliance and help to prevent a fire. If the oven gets too hot, this fuse trips. The thermal fuse is not resettable and will have to be replaced. It can be checked for continuity. If it has continuity, it's OK.

Place your order by 8:00 PM ET and this item will ship out today - or it's FREE!


Back to Symptom List