Enter Part or Model Number for best results

(Where is my model number?)

Frigidaire Refrigerator Ice Maker Not Working

FRS20ZRG

The 6 most common part(s) or condition(s) which contribute to the symptom Refrigerator ice maker not working are listed below. Check or test each item and watch any available videos. If you are still unable to solve the problem you may need to do additional research and troubleshooting. Remember, with our 365 Days. Period.® return policy you can return any part for any reason. So, go ahead and buy it to try it. No other parts retailer offers this unconditional return policy.

For the symptom you selected, these are the most common parts or causes, ordered by the likelihood of fixing the symptom.

Other Causes and Conditions

Freezer Temperature is Above 10 Degrees F (-12C)

If the ice maker is not working check the temperature of the freezer. If the freezer temperature is above 10 degrees F. (-12C) the ice maker will not work properly. It functions best when the freezer temperature is set between 0 and five degrees F. (-18 to -15C). If the freezer temp is too high make sure the condenser coil is clean and the condenser fan is working to cool the condenser and compressor. Check the evaporator coil for frost. If too much frost is built up the air can't circulate thru the coil and you will need to check the defrost components for a failure.

Grid is 1 inch square
Ice Maker Assembly - Part # 941760 Mfg Part # 5303918277

Ice Maker Assembly

RepairClinic Item # 941760

If the ice maker is not working it could be that the ice maker assembly itself is defective. The freezer temp should be between 0-5 degrees for the ice maker to cycle properly. There are several components in the control module of the ice maker that can fail and most are not sold separately. Also, ice makers have a relatively short lifespan and so it might not be worth fixing. If other, simpler parts like the water inlet valve or shut off arm have been ruled out, and the only thing left is the ice maker itself, replace it as a unit.

Place your order by 8:00 PM ET and this item will ship out today - or it's FREE!

$94.35

Other Causes and Conditions

Low Water Pressure from House Supply

If the ice maker is not working the water pressure in the house might be too low. The water inlet valve which supplies water to the ice maker is designed to work with a minimum of 20 psi of water pressure.

Grid is 1 inch square
Door Switch - Part # 1193 Mfg Part # 5303289051

Door Switch

RepairClinic Item # 1193

If the refrigerator ice maker is not working, the door switch might be defective. When the freezer door is opened the freezer door switch does two things, it turns on the light in the freezer and turns off the ice maker and dispenser. If the door switch fails the dispenser will not turn on. The switch can be checked for continuity with an Ohm meter. If it doesn’t have continuity it should be replaced.

Place your order by 8:00 PM ET and this item will ship out today - or it's FREE!

$9.20

Grid is 1 inch square
Water Filter - Part # 277187 Mfg Part # WFCB

Water Filter

RepairClinic Item # 277187

If the refrigerator ice maker is not working the water filter might be clogged. Try changing the water filter.

Place your order by 8:00 PM ET and this item will ship out today - or it's FREE!

$36.20

Grid is 1 inch square
Icemaker Mold Thermostat - Part # 510387 Mfg Part # 3206322

Icemaker Mold Thermostat

RepairClinic Item # 510387

If the ice maker is not working the icemaker mold thermostat might be defective. Inside the control module of the ice maker is a thermostat which monitors the temperature of the ice mold (ice tray). Once the mold reaches the proper temperature the ice maker starts a harvest cycle by ejecting the ice cubes and refilling with water. If the mold thermostat is defective the ice maker doesn't advance. The thermostat can be checked for continuity. Replace it as needed.The freezer temp should be between 0-5 degrees for optimum performance.

Back to Symptom List