Enter Part or Model Number for best results

(Where is my model number?)

Frigidaire Washer is Making Loud Noise

FTR630AS0

The 6 most common part(s) or condition(s) which contribute to the symptom Washer is making loud noise are listed below. Check or test each item and watch any available videos. If you are still unable to solve the problem you may need to do additional research and troubleshooting. Remember, with our 365 Days. Period.® return policy you can return any part for any reason. So, go ahead and buy it to try it. No other parts retailer offers this unconditional return policy.

For the symptom you selected, these are the most common parts or causes, ordered by the likelihood of fixing the symptom.

Grid is 1 inch square
Rear Drum with Bearing - Part # 407639 Mfg Part # 131525500

Rear Drum with Bearing

RepairClinic Item # 407639

If the washer is making a loud noise the rear drum with bearing might need to be replace. On this washer the bearing might not be sold separately, the entire rear drum might have to be replaced. This is a very involved repair and will require disassembling most of the washer. However, the problem is going to get worse very quickly and so either the drum and bearing will need to be replaced or the washing machine.

Oversize Part – Special Shipping Required

Place your order by 8:00 PM ET and this item will ship out today - or it's FREE!

$244.70

Grid is 1 inch square
Drive Pulley - Part # 780798 Mfg Part # 131883400

Drive Pulley

RepairClinic Item # 780798

If the washer is making a loud noise the drive pulley might be worn out, cracked, loose or bent. Remove the drive pulley and inspect it carefully. If it is damaged or defective replace it.

Place your order by 8:00 PM ET and this item will ship out today - or it's FREE!

$127.50

Grid is 1 inch square
Drive Belt - Part # 916708 Mfg Part # 134051000

Drive Belt

RepairClinic Item # 916708

If the washer is making a loud noise the drive belt might be defective. Over time the drive belt will dry out and start cracking, eventually a piece of the belt can break off resulting in a loud noise whenever the motor is running.

Place your order by 8:00 PM ET and this item will ship out today - or it's FREE!

$27.15

Grid is 1 inch square
Drain Pump - Part # 1467804 Mfg Part # 137108000

Drain Pump

RepairClinic Item # 1467804

If the washer is making a loud noise the drain pump might be going bad or might have something caught in it. Remove the drain pump from the washer and inspect it carefully. Look for anything that might be caught in it, a piece of wire, plastic, etc. If nothing is wrong with the pump, but it's still noisy it will have to be replaced.

Place your order by 8:00 PM ET and this item will ship out today - or it's FREE!

$81.70

Grid is 1 inch square
Drive Motor - Part # 1378616 Mfg Part # 134869400

Drive Motor

RepairClinic Item # 1378616

If the washer is making a loud noise the drive motor bearings may have worn out. Washer motors are normally almost silent when they run. If the motor is run without a belt hooked up to it and it's loud it will have to be replaced.

Place your order by 8:00 PM ET and this item will ship out today - or it's FREE!

$150.60

Grid is 1 inch square
Water Inlet Valve - Part # 1014339 Mfg Part # 134190200

Water Inlet Valve

RepairClinic Item # 1014339

If the washer is noisy or loud, particularly when the washer is filling, the water inlet valve may be at fault. The noise can be caused by a restriction in the valve from mineral deposits. If it is the water inlet valve that's loud during the fill cycle it will need to be replaced. It is not safe to take apart these valves as they can fail and flood after disassembly.

Place your order by 8:00 PM ET and this item will ship out today - or it's FREE!

$18.65

Back to Symptom List