Enter Part or Model Number for best results

(Where is my model number?)

Maytag Washer is Making Loud Noise

MAH5500BWW

The 10 most common part(s) or condition(s) which contribute to the symptom Washer is making loud noise are listed below. Check or test each item and watch any available videos. If you are still unable to solve the problem you may need to do additional research and troubleshooting. Remember, with our 365 Days. Period.® return policy you can return any part for any reason. So, go ahead and buy it to try it. No other parts retailer offers this unconditional return policy.

For the symptom you selected, these are the most common parts or causes, ordered by the likelihood of fixing the symptom.

Grid is 1 inch square
Rear Drum with Bearing - Part # 1119942 Mfg Part # 22004465

Rear Drum with Bearing

RepairClinic Item # 1119942

If the washer is making a loud noise the rear drum with bearing might need to be replace. On this washer the bearing might not be sold separately, the entire rear drum might have to be replaced. This is a very involved repair and will require disassembling most of the washer. However, the problem is going to get worse very quickly and so either the drum and bearing will need to be replaced or the washing machine.

Special Shipping Required

Order now and this item will ship out tomorrow - or it's FREE!

Grid is 1 inch square
Pulley - Part # 824614 Mfg Part # 22002315

Pulley

RepairClinic Item # 824614

If the washer is making a loud noise the drive pulley may be worn out. If the drive pulley is loose or wobbling it will need to be replaced

Order now and this item will ship out tomorrow - or it's FREE!

Grid is 1 inch square
Drive Belt - Part # 785411 Mfg Part # 12001788

Drive Belt

RepairClinic Item # 785411

If the washer is making a loud noise the drive belt might be defective. Over time the drive belt will dry out and start cracking, eventually a piece of the belt can break off resulting in a loud noise whenever the motor is running.

Order now and this item will ship out tomorrow - or it's FREE!

Grid is 1 inch square
Drain Pump - Part # 1033134 Mfg Part # 25001052

Drain Pump

RepairClinic Item # 1033134

If the washer is making a loud noise the drain pump might be going bad or might have something caught in it. Remove the drain pump from the washer and inspect it carefully. Look for anything that might be caught in it, a piece of wire, plastic, etc. If nothing is wrong with the pump, but it's still noisy it will have to be replaced.

Order now and this item will ship out tomorrow - or it's FREE!

Grid is 1 inch square
Drive Motor - Part # 893321 Mfg Part # 12001808

Drive Motor

RepairClinic Item # 893321

If the washer is making a loud noise the drive motor bearings may have worn out. Washer motors are normally almost silent when they run. If the motor is run without a belt hooked up to it and it's loud it will have to be replaced.

Grid is 1 inch square
Drive Motor - Part # 949491 Mfg Part # 12002039

Drive Motor

RepairClinic Item # 949491

If the washer is making a loud noise the drive motor bearings may have worn out. Washer motors are normally almost silent when they run. If the motor is run without a belt hooked up to it and it's loud it will have to be replaced.

Order now and this item will ship out tomorrow - or it's FREE!

Grid is 1 inch square
Drive Motor - Part # 1000901 Mfg Part # 22003856

Drive Motor

RepairClinic Item # 1000901

If the washer is making a loud noise the drive motor bearings may have worn out. Washer motors are normally almost silent when they run. If the motor is run without a belt hooked up to it and it's loud it will have to be replaced.

Order now and this item will ship out tomorrow - or it's FREE!

Grid is 1 inch square
Water Inlet Valve - Part # 791006 Mfg Part # 22003245

Water Inlet Valve

RepairClinic Item # 791006

If the washer is noisy or loud, particularly when the washer is filling, the water inlet valve may be at fault. The noise can be caused by a restriction in the valve from mineral deposits. If it is the water inlet valve that's loud during the fill cycle it will need to be replaced. It is not safe to take apart these valves as they can fail and flood after disassembly.

Order now and this item will ship out tomorrow - or it's FREE!

Grid is 1 inch square
Water Inlet Valve - Part # 997846 Mfg Part # 12001930

Water Inlet Valve

RepairClinic Item # 997846

If the washer is noisy or loud, particularly when the washer is filling, the water inlet valve may be at fault. The noise can be caused by a restriction in the valve from mineral deposits. If it is the water inlet valve that's loud during the fill cycle it will need to be replaced. It is not safe to take apart these valves as they can fail and flood after disassembly.

Order now and this item will ship out tomorrow - or it's FREE!

Grid is 1 inch square
Water Inlet Valve - Part # 1000881 Mfg Part # 22003834

Water Inlet Valve

RepairClinic Item # 1000881

If the washer is noisy or loud, particularly when the washer is filling, the water inlet valve may be at fault. The noise can be caused by a restriction in the valve from mineral deposits. If it is the water inlet valve that's loud during the fill cycle it will need to be replaced. It is not safe to take apart these valves as they can fail and flood after disassembly.

Order now and this item will ship out tomorrow - or it's FREE!

Back to Symptom List