Enter Part or Model Number for best results

(Where is my model number?)

Whirlpool Washer is Making Loud Noise

WFW9550WW00

The 6 most common part(s) or condition(s) which contribute to the symptom Washer is making loud noise are listed below. Check or test each item and watch any available videos. If you are still unable to solve the problem you may need to do additional research and troubleshooting. Remember, with our 365 Days. Period.® return policy you can return any part for any reason. So, go ahead and buy it to try it. No other parts retailer offers this unconditional return policy.

For the symptom you selected, these are the most common parts or causes, ordered by the likelihood of fixing the symptom.

Grid is 1 inch square
Rear Drum with Bearing - Part # 1549334 Mfg Part # W10250806

Rear Drum with Bearing

RepairClinic Item # 1549334

If the washer is making a loud noise the rear drum with bearing might need to be replace. On this washer the bearing might not be sold separately, the entire rear drum might have to be replaced. This is a very involved repair and will require disassembling most of the washer. However, the problem is going to get worse very quickly and so either the drum and bearing will need to be replaced or the washing machine.

Oversize Part – Special Shipping Required

Grid is 1 inch square
Drive Pulley - Part # 1154620 Mfg Part # 8182650

Drive Pulley

RepairClinic Item # 1154620

If the washer is making a loud noise the drive pulley might be worn out, cracked, loose or bent. Remove the drive pulley and inspect it carefully. If it is damaged or defective replace it.

Place your order by 8:00 PM ET and this item will ship out today - or it's FREE!

$50.40

Grid is 1 inch square
Drive Belt - Part # 2024684 Mfg Part # W10388414

Drive Belt

RepairClinic Item # 2024684

If the washer is making a loud noise the drive belt might be defective. Over time the drive belt will dry out and start cracking, eventually a piece of the belt can break off resulting in a loud noise whenever the motor is running.

Place your order by 8:00 PM ET and this item will ship out today - or it's FREE!

$26.30

Grid is 1 inch square
Drain Pump - Part # 1373005 Mfg Part # W10130913

Drain Pump

RepairClinic Item # 1373005

If the washer is making a loud noise the drain pump might be going bad or might have something caught in it. Remove the drain pump from the washer and inspect it carefully. Look for anything that might be caught in it, a piece of wire, plastic, etc. If nothing is wrong with the pump, but it's still noisy it will have to be replaced.

Place your order by 8:00 PM ET and this item will ship out today - or it's FREE!

$109.40

Grid is 1 inch square
Drive Motor - Part # 1451095 Mfg Part # W10140583

Drive Motor

RepairClinic Item # 1451095

If the washer is making a loud noise the drive motor bearings may have worn out. Washer motors are normally almost silent when they run. If the motor is run without a belt hooked up to it and it's loud it will have to be replaced.

Grid is 1 inch square
Water Inlet Valve - Part # 1549047 Mfg Part # W10247305

Water Inlet Valve

RepairClinic Item # 1549047

If the washer is noisy or loud, particularly when the washer is filling, the water inlet valve may be at fault. The noise can be caused by a restriction in the valve from mineral deposits. If it is the water inlet valve that's loud during the fill cycle it will need to be replaced. It is not safe to take apart these valves as they can fail and flood after disassembly.

Back to Symptom List