GO
SEARCH:

GE Washer Vibration

WJSR2080T2WW

The 5 most common part(s) or condition(s) which cause the symptom Washer vibration are listed below starting with the most likely. Check or test each item and watch any available videos.

Grid is 1 inch square
Support Bracket - Part # 280858 Mfg Part # WH46X10019

Support Bracket

RepairClinic Item # 280858

Washer vibration can occur if the support bracket is broken. Check the bracket for any damage or wear, replace as needed.

$63.40

Order now and this item will ship out tomorrow

Add to Cart

365 Day Return Policy

Grid is 1 inch square
Suspension Rod - Part # 278863 Mfg Part # WH16X519

Suspension Rod

RepairClinic Item # 278863

Washer vibration can occur if one or more suspension rods are broken. Check all four rods, replace any that are broken.

 

Grid is 1 inch square
Shipping Bolt - Part # 280980 Mfg Part # WH46X344

Shipping Bolt

RepairClinic Item # 280980

Washer vibration can occur if the shipping bolts have not been removed. All front loading washers are delivered with shipping bolts to stabilize the drum system during transportation. The bolts are located at the back of the washer and they must be removed before use otherwise the machine will shake and bounce around significantly.

$11.60

Order now and this item will ship out tomorrow

Add to Cart

365 Day Return Policy

Grid is 1 inch square
Balance Ring - Part # 280792 Mfg Part # WH45X152

Balance Ring

RepairClinic Item # 280792

If the washer has excessive vibration, the balance ring may have lost its fluid. The balance ring sits on top of the outer tub and helps to counter the force of the spin cycle. If the fluid leaks out of the balance ring the washer tub will be too heavy for the suspension system and cause the machine to vibrate and shake.

Oversize Part – Special Shipping Required

$45.30

Order now and this item will ship out tomorrow

Add to Cart

365 Day Return Policy

Grid is 1 inch square
Leveling Leg - Part # 279126 Mfg Part # WH2X1187

Leveling Leg

RepairClinic Item # 279126

Washer vibration can occur if one of the leveling legs is out of adjustment. Using a carpenters level on the top of the machine, be sure to adjust each leg until the machine is level side to side and front to back. Once the machine is level, tighten the lock nuts, if equipped, on the leveling leg threaded bolt against the body of the washer to keep them from changing height.

$9.15

Order now and this item will ship out tomorrow

Add to Cart

365 Day Return Policy

Back to Symptom List