GO
SEARCH:

Whirlpool Washer Overflowing

LSR7233DQ0

The 3 most common part(s) or condition(s) which cause the symptom Washer overflowing are listed below starting with the most likely. Check or test each item and watch any available videos.

Grid is 1 inch square
Water Inlet Valve - Part # 868761 Mfg Part # 285805

Water Inlet Valve

RepairClinic Item # 868761

If the washer is overflowing and power is shut off to the washer, the water inlet valve has failed. Replace it.

$17.25

Order by 3:00 PM ET and choose FedEx 2Day or FedEx Overnight shipping, this part ships TODAY!

Add to Cart

365 Day Return Policy

Grid is 1 inch square
Pressure Switch - Part # 520939 Mfg Part # 3356467

Pressure Switch

RepairClinic Item # 520939

If the washer is overflowing the pressure switch might be defective. The pressure switch is attached to a small tube which is attached to the outer wash tub. As the water level rises the air pressure in the tube increases, once the set water level is reached the pressure switch turns off power to the water inlet valve. Check to be sure the air tube to the pressure switch is clear before replacing the switch.

$50.10

Order by 3:00 PM ET and choose FedEx 2Day or FedEx Overnight shipping, this part ships TODAY!

Add to Cart

365 Day Return Policy

Other Causes and Conditions

Low Water Pressure from House Supply

If the washer is overflowing the water pressure to the water inlet valve might be too low. The water inlet valve requires a minimum of 20 psi to shut off properly. If the pressure is lower, the valve may not close fully when the power is shut off. This results in the valve leaking water into the washer and causing it to overflow.

Back to Symptom List