Speed Queen Washer/Dryer Combo Parts

Gas burner valve solenoids. Kit contains both the two wire and three wire solenoids. One solenoid is the primary and one is the safety. Both have to operate for the gas valve to open. Usually, one of them burns out but you should always replace them as a set.

Manufacturer Number 279834

These often fail intermittently, making diagnosis difficult. To test, watch the burner assembly while the dryer is heating. If the igniter glows for a while and then shuts off without the gas turning on, it usually means one of these coils is bad.

Gas dryer sensor for igniter and flame

Manufacturer Number 338906

This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

Idler pulley wheel and bearing assembly

Manufacturer Number Y54414

Door catch kit, includes catch and clip (metal)

Manufacturer Number LA-1003

Retainer snap ring

Manufacturer Number 23748

Idler wheel/drum roller shaft

Manufacturer Number 56461

Door switch kit. *Replaces older 2 terminal switches.

Manufacturer Number W10169313

Cylinder felt seal

Manufacturer Number 37001132

5-foot-long rubber washing machine fill hose. For hot or cold water. *Also order related hose washers if needed.

Manufacturer Number 89503

Replace inlet hoses after 5 years of use to reduce the risk of hose failure.

Washer 3/4 inch outside diameter

Manufacturer Number 233520

Felt pad

Manufacturer Number 510189

Door catch kit, includes catch and clip (plastic)

Manufacturer Number 306436

Washer lid switch assembly complete with fuse *Open fuse indicates bad lid switch assembly.

Manufacturer Number 22001682

Watch our “Part Testing” video to determine if the switch has failed and needs to be replaced.

Adjustable leveling leg with stop-nut

Manufacturer Number 22003428