Washer/Dryer Combo Parts

Dryer drum slide. There are two of these needed on your dryer. These go on the outer most slots on the front bearing. Sold individually will need to purchase two*

Manufacturer Number WE1M504

The drum slides support the front of the dryer drum instead of rollers or bearings. As they wear out the dryer will make more noise.

Dryer drum slide. There are two of these needed on your dryer. These go on the inner most slots on the front bearing. Sold individually will need to purchase two*

Manufacturer Number WE1M1067

The drum slides support the front of the dryer drum instead of rollers or bearings. As they wear out the dryer will make more noise.

Thermal fuse. If the dryer overheats, this device stops the flow of electricity to the heat source and/or the entire dryer. It is located on the blower housing and cannot be reset. The most common cause for overheating is a vent tube clogged with lint, a birds nest or other debris.

Manufacturer Number 3392519

Watch our “Part Testing” video to determine if the thermal fuse has blown out and needs to be replaced.

Drive motor coupler. New style with metal sleeves for added strength. This version replaces all previous motor coupler styles and versions. For direct drive washing machines.

Manufacturer Number 285753A

Common symptom of failed coupler is washer will fill, not agitate or spin but will drain the water from the tub.

Dryer belt. This is the most common belt used on Whirlpool, Kenmore, Kitchenaid, Roper, Estate and other dryer brands. The belt is flat, 92-1/4 inches long, 1/4 inch wide and has 4 ribs and 3 grooves. It replaces many other belts, including some with 5 ribs and 4 grooves.

Manufacturer Number 341241

See our dryer belt diagram to see how this belt should be installed around the motor and idler pulleys.

Gas burner valve solenoids. Kit contains both the two wire and three wire solenoids. One solenoid is the primary and one is the safety. Both have to operate for the gas valve to open. Usually, one of them burns out but you should always replace them as a set.

Manufacturer Number 279834

These often fail intermittently, making diagnosis difficult. To test, watch the burner assembly while the dryer is heating. If the igniter glows for a while and then shuts off without the gas turning on, it usually means one of these coils is bad.

Dryer heating element. If your dryer does not heat, enter your model number into our Repair Help Section as this part is not the most common cause.

Manufacturer Number 279838

Normally, if you remove the old element a defective part will have a physical break in it. It can also be tested using a multimeter.See our Repair Help section for additional information

Front drum bearing. NOTE: The drum slides should also be replaced and are NOT included with this part, you must purchase two of each separately. Please see the "Related Items" for this part.

Manufacturer Number WE3M26

Drain pump for belt-less direct-drive washer, one large port, one small port.

Manufacturer Number 3363394

Mounts directly to the motor with two clips. A leaking pump may cause a small puddle in the front of the washer.

Washing machine agitator repair kit with a medium length cam (there are other kits available for different models). This kit should be used when the top part of the agitator is not moving properly but the bottom part is.

Manufacturer Number 285811

Drum support roller with bearing

Manufacturer Number 12001541

Both rollers should be replaced at the same time

Washing machine agitator directional cogs, also known as "dog ears", 4 per package

Manufacturer Number 80040

Drain pump and motor assembly

Manufacturer Number 4681EA2001T

Rear dryer drum bearing kit

Manufacturer Number 5303281153