Whirlpool Dryer Parts

Dryer belt. This is the most common belt used on Whirlpool, Kenmore, Kitchenaid, Roper, Estate and other dryer brands. The belt is flat, 92-1/4 inches long, 1/4 inch wide and has 4 ribs and 3 grooves. It replaces many other belts, including some with 5 ribs and 4 grooves.

Manufacturer Number 341241

See our dryer belt diagram to see how this belt should be installed around the motor and idler pulleys.

Gas burner valve solenoids. Kit contains both the two wire and three wire solenoids. One solenoid is the primary and one is the safety. Both have to operate for the gas valve to open. Usually, one of them burns out but you should always replace them as a set.

Manufacturer Number 279834

These often fail intermittently, making diagnosis difficult. To test, watch the burner assembly while the dryer is heating. If the igniter glows for a while and then shuts off without the gas turning on, it usually means one of these coils is bad.

Thermal fuse. If the dryer overheats, this device stops the flow of electricity to the heat source and/or the entire dryer. It is located on the blower housing and cannot be reset. The most common cause for overheating is a vent tube clogged with lint, a birds nest or other debris.

Manufacturer Number 3392519

Watch our “Part Testing” video to determine if the thermal fuse has blown out and needs to be replaced.

Dryer heating element assembly, 220 volts. When the element burns out it must be replaced, it cannot be repaired.

Manufacturer Number 279838

Watch our “Part Testing” video to determine if the dryer heating element has burned out and needs to be replaced.

Heating element thermal cut-off (thermal fuse) 309 degrees and high-limit thermostat 250 degrees, with wiring kit.

Manufacturer Number 279816

Watch our “Part Testing” video to determine if the thermal fuse has blown out and needs to be replaced.

Repair kit for Whirlpool, Kenmore, Roper dryer; rollers, belt and idler pulley, for 29" wide Dryers built 1965 and later

Manufacturer Number 4392065

Igniter kit, will replace round or flat style, with bracket, wire nuts and mounting screw. Caution! The black heating element portion of this part is EXTREMELY fragile. Use caution when handling.

Manufacturer Number 279311

Watch our “Part Testing” video to determine if the dryer igniter has burned out and needs to be replaced.

Heating element assembly, 240 volts

Manufacturer Number 3387747

Watch our “Part Testing” video to determine if the dryer heating element has burned out and needs to be replaced.

Door switch assembly

Manufacturer Number 3406107

Heating element thermal cut-off (thermal fuse) 360 degrees and high-limit thermostat 250 degrees.

Manufacturer Number 279769

Watch our “Part Testing” video to determine if the thermal fuse has blown out and needs to be replaced.

Dryer cycling thermostat with internal bias heater, L155-25

Manufacturer Number 3387134

Motor, dryer drum drive with pulley for belt

Manufacturer Number 279827

Gas dryer sensor for igniter and flame

Manufacturer Number 338906

This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

240v dryer heating element with wires

Manufacturer Number 4391960

Watch our “Part Testing” video to determine if the dryer heating element has burned out and needs to be replaced.