Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.
Dryer drum drive belt. Length 93 3/8”, width 3/8”, characteristics, 5 ridges, flat. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley.
Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.
Idler pulley wheel and bearing assembly. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin.
Three terminal door switch kit. Be aware that this switch replaces older 2 terminal switches.
Igniter (Bracket is no longer included.) If your old igniter was round you will need to order the bracket in the related parts below.
Dryer door catch kit. Includes door catch and clip (plastic)
Washer. Has a 3/4-inch outside diameter.
Retainer snap ring. Used to hold drum rollers and idler pulleys in place.
Screw, 10-24 3/8
Light bulb, 7 Watt
Door catch kit, includes catch and clip (metal) Replace both parts for best results
Rubber leveling leg foot.
Front cover top retaining spring clip