Furnace draft inducer mounting grommet. This grommet helps isolate the blower assembly from the furnace to reduce noise.
Furnace draft inducer motor cooling fan blade and clip. You may have to cut the old clip off to remove the fan blade.
Nitride Hot Surface Furnace Ignitor
Flame rollout limit switch re-settable 350F
Limit switch non-resettable 101-200F
Inducer fan wheel
Gasket, draft inducer housing
Draft inducer motor
Carrier furnace circuit board. This circuit board regulates the supply of power to the furnace components.
Limit switch 125-165F
Furnace blower wheel. 12" X 11.93" 1/2" Bore. The blower wheel blows air out of the furnace and through the house. The blower wheel is attached to the blower motor shaft with a set screw. If the set screw is loose, the blower wheel will wobble on the motor shaft and be noisy as it turns.
Furnace draft inducer motor kit. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.