Run Capacitor. Single, Oval, 370 volt, 5 Microfarad.
Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.
Furnace blower motor. This single-phase motor has the following specifications:
Horsepower: 1/3
Voltage: 115
Full-Load Amperage: 5.1
Hertz: 60
RPM: 1075
Speeds: 4
Rotation: Counterclockwise
Frame: 48
Enclosure: Open
Shaft Length: 4.25”
Control center
Flame rollout limit switch - manual reset
Pilot and spark igniter assembly
Flame sensor wire lead
Gas valve 1/2" I.P. Natural Gas, SlowOpen 24V
Harness-wiring