Run Capacitor. Single, Oval, 370 volt, 5 Microfarad.
Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.
Capacitor single run 7.5 MFD 370 Volt oval
Furnace blower motor. This single-phase motor has the following specifications:
Full-Load Amperage: 5.1
Shaft Length: 4.25”
Transformer, 120 Volt Primary 24 Volt Secondary 40 VA
Main Gas Burner Assembly Four Tube
1/2HP 115Volts 60Hz 8 amp 1075 RPM's 5 Speed Open Enclosure 48Y Frame Single Phase CCW 3" Shaft. Any unused wires will need to be taped off or put on the "park" terminals on the control board. These terminals are there specifically for unused wires.
Wheel-blower 10" x 8" 1/2"bore
Flame sensor wire lead
Circuit Breaker Switch