Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.
Limit rollout control
Capacitor single run 7.5 MFD 370 Volt oval
1/2HP 115Volts 60Hz 8 amp 1075 RPM's 5 Speed Open Enclosure 48Y Frame Single Phase CCW 3" Shaft. Any unused wires will need to be taped off or put on the "park" terminals on the control board. These terminals are there specifically for unused wires.
Blower wheel, 10 5/8 length 10 5/8 diameter, 1/2 inch bore
Main Gas Burner Assembly Four Tube
.85 WC Pressure Switch
Furance control board
Circuit Breaker Switch
Transformer 120v pri, 24v sec, 40va