Whirlpool Washing Machine Model WTW4800XQ4 Parts
Featured parts for Whirlpool Washing Machine
Washing machine agitator directional cogs. These parts are also referred to as "dog ears." 4 per package. If the upper section of the agitator isn't turning properly, then these cogs are likely worn and will require replacement.
Affresh® Washing machine cleaner. This cleaner removes and prevents odor-causing residue in all brands of washers. To use, add one tablet to washer with no clothes and select hot water.
- Septic safe
- More effective than bleach.
- Three tablets per package.
Washing machine tub suspension rod kit,. Set of 4 rods, 4 suspension balls and 4 bushings. The suspension rods help to dampen the movement of the washer tub. If one or more of the suspension rods are broken, the washer will vibrate or shake.
Drive Clutch Kit. This kit has 6 parts; a spring, housing, cam ring, basket drive gear, pulley, and nut. The pulley is driven by the drive belt and the splutch works with the mode shift actuator to operate the washplate and spin the inner basket. A worn splutch can cause spin or washplate problems.
Washing machine mode shift actuator. *Updated by the manufacturer, does not look like original part. Actuator serves several functions. It has a synchronous motor that shifts the splutch cam ring and monitors the position of the splutch. Also has transmission speed/position optical sensor
Washer main drive belt. This belt is located under the washing machine and is used to drive the splutch pulley. It goes around the motor & splutch pulleys. Worn or broken drive belt can cause spin or washplate problems.
Includes latch assembly, one white and one gray lid lock bezel. Lid must be closed for washer to fill, wash, drain, or spin. If the machine is not advancing into the cycle or is displaying a lid lock fault this may be the cause of the issue.
Washing Machine agitator repair kit. Includes short cam. The teeth on the dog ears often wear out and cause the top of the agitator not to work properly.
Package of two 5-foot-long Industrial Braid hoses with pre-installed washers and straight ends. It is recommended to replace washing machine inlet hoses after 5 years of use to reduce the risk of hose failure.
Washing machine agitator assembly. If the washer does not agitate, the agitator might be damaged or stripped away at the point where it connects to the drive system.
Washing machine drain pump. If the washer does not drain then the drain pump may be clogged, damaged, or defective.
Start doing it yourself with the confidence that comes with 100+ years of experience. We've got millions of parts, hundreds of brands, and thousands of step-by-step videos— everything you need to find it, fix it and finish the job right.
