Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.
Stainless steel burner
Hot surface furnace ignitor with plug on connector
Thermal limit switch, open at 180 degrees, close at 150 degrees
HSI control module with four wire leads
Transformer; 115v pri, 24v sec., 60hz, 35va, foot mount
Flame rollout switch. Push red button to reset. L310
Transition receptacle, includes four mounting screws
Capacitor; 440 vac oval motor run, 15 mfd
Door switch, 21 amps, 125/250 vac
Draft inducer motor, one stage with shaded pole motor *Note: All models use this part with the exception of: *UX/DX100A, UX/DX100C, UX/DX1C100, UX1D100, UX/DX120A, UX/DX120C. These select models use item 2458691.
1/2HP 115Volts 60Hz 9.35 amp 1075 RPM's 4 Speed Open Enclosure 48Y Frame Single Phase CCW 3" Shaft
10 in diameter x 10 in width. .50 BC. Clockwise rotation
Resilient ring, 2 required
Brass orifice spud, drill #45