Furnace hot surface igniter kit. The igniter gets very hot and glows bright orange to light the gas burner. If the igniter is cracked or defective, the furnace won’t heat.
Furnace control board. The control board regulates the supply of power to the furnace components.
Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.
Genteq Run Capacitor 370 Volt Oval Single 7.5 MFD
Gas Burner Tube
Blade fuse. ATC-3 (3 Amp)
Draft inducer blower assembly. 60 Hz 1.75 Amps, 3000 RPM
Gas valve kit
High limit thermostat -140 open, 110 close
Furnace blower motor. This single-phase motor has the following specifications:
Full-Load Amperage: 10.7
Flame rollout limit switch 185 degrees F open, manual reset
Orifice,burner drill size 45
Flame rollout limit switch. 350 degrees F Open, Manual Reset
Natural gas to LP conversion kit. *Should be installed by a certified York repairperson.