Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.
Contactor, 2 pole, 25 amp, 24 vac **Special Note** This may replace single pole contactor and require a technican to install (based on model #)
Motor, 1/4 hp, 1 sp, 6 pl
Flame rollout switch, L350F
Run cap 35/5mfd/440v/dual round
Gas valve, single stage, HW
10 x 6 blower wheel cw
Run capacitor single oval 370V 7.5uF
18" fan blade 3blade 29pitch
1/3hp 208/230v 1ph 1075rpm
Square to round chimney kit
Direct spark ignitor
Draft Inducer blower motor with gasket (Ventor assembly).
Condenser Fan Motor - 1/6 HP 208-230Volts 60Hertz 1Amps 1075RPM Single Speed Closed Enclosure Frame Single Phase CCW Rotation 3" Shaft