Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.
Run capacitor, round 440 volt 45/5 uF
Contactor, 2 pole, 25 amp, 24 vac **Special Note** This may replace single pole contactor and require a technican to install (based on model #)
Flame rollout switch, L350F
Motor, 1/4 hp, 1 sp, 6 pl
Gas valve, single stage, HW
Run capacitor single oval 370V 7.5uF
10 x 6 blower wheel cw
Square to round chimney kit
Direct spark ignitor
1/3hp 208/230v 1ph 1075rpm
Draft Inducer blower motor with gasket (Ventor assembly).
Bracket f/rollout swut switch