Furnace draft inducer mounting grommet. This grommet helps isolate the blower assembly from the furnace to reduce noise.
Furnace draft inducer motor cooling fan blade and clip. You may have to cut the old clip off to remove the fan blade.
Gas burner tube
Furnace draft inducer motor with cooling fan. Be aware that the screw holes are not threaded—you will need to use self-tapping screws to install the motor.
Gasket kit for draft inducer motor
Blower wheel for draft inducer motor 4" Diameter 1.5" Width
Grommet, motor mounting bracket. Sold as a single grommet but we suggest purchasing three since there are 3 holding the motor in place, and it’s a good practice to change all of them while the assembly is taken apart.
High limit thermostat, 180 degrees Fahrenheit
Screw assy 1/4 hex
Thermocouple, 36 inches