Furnace draft inducer mounting grommet. This grommet helps isolate the blower assembly from the furnace to reduce noise.
Nitride Hot Surface Furnace Ignitor
Furnace draft inducer motor cooling fan blade and clip. You may have to cut the old clip off to remove the fan blade.
Flame rollout limit switch re-settable 350F
Gasket, draft inducer housing
Inducer fan wheel
Limit switch non-resettable 101-200F
Draft inducer motor
Carrier furnace circuit board. This circuit board regulates the supply of power to the furnace components.
Furnace draft inducer motor kit. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.
Grommet, sold individually
Blower Motor - 1/3HP 115Volts 60Hz 4.8 amp 1075 RPM's 3 Speed Open Enclosure 48Y Frame Single Phase CCW 4.73" Shaft