Rear drum support roller kit. This kit contains two drum support rollers. If the drum rollers are worn out, the dryer may not turn properly or may be excessively noisy. Be aware that the drum bearings are self-lubricating; it is not necessary to lubricate them yourself.
Refrigerator icemaker. This item does not include a new shut off arm. To remove the existing shut off arm from the old icemaker, lift it to the up position, unhook it from the fill cup bearing, and pull it out of the module.
Dryer belt tension idler pulley assembly.When the idler pulley goes bad it will usually make a high pitch squeeling or rattling noise.
Dryer igniter kit. This igniter will replace both round and flat style igniters. The kit includes the bracket, wire nuts and mounting screw. Be aware the igniter is very fragile and should be handled carefully.
Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.
Refrigerator defrost timer kit. This timer is designed for continuous or cumulative run defrost systems. Turn the dial on the timer clockwise to advance it into and out of defrost.
Dryer foam seal with adhesive backing. This seals goes between the lint chute and the bulkhead. 28 in
Dryer door/washer lid switch kit. Comes with dryer mounting bracket, (2) wire terminals and (2) mounting screws.
Icemaker water fill tube with compression nut. Approximately 9 1/2 inches long. Can be cut to match the length of the original tube.