Refrigerator icemaker. This item does not include a new shut off arm. To remove the existing shut off arm from the old icemaker, lift it to the up position, unhook it from the fill cup bearing, and pull it out of the module.
Refrigerator or freezer lower door closing cam. A new screw is needed to mount the cam. Consider lubricating the cam during installation.
White touch-up paint. .6 oz.
Refrigerator/freezer temperature control thermostat. Temperature issues can be caused by this thermostat.
Refrigerator defrost timer kit. This timer is designed for continuous or cumulative run defrost systems. Turn the dial on the timer clockwise to advance it into and out of defrost.
Refrigerator defrost thermostat. The thermostat clips onto the evaporator. If the refrigerator does not defrost both the thermostat and heater can be tested to determine which part is at fault.
Spray paint, white, 12 ounces
Door closing cam kit for bottom of refrigerator/freezer door hinges. This closing cam enables the door to close on its own. Consider lubricating the cam during installation.
Complete add-on icemaker kit, Fits all Whirlpool, KitchenAid and Roper 1984-1993 plastic-liner refrigerators with 28" and 31" wide cabinets.
Refrigerator icemaker control module and motor assembly. Located under the white cover of icemaker and controls ice ejector bar, heater and water inlet valve for the icemaker. If the icemaker is not making ice or making too much ice the model may be defective.
Icemaker water fill tube with compression nut. Approximately 9 1/2 inches long. Can be cut to match the length of the original tube.
All-purpose silicon grease, ½ oz. Not food grade.
Refrigerator evaporator fan motor. The evaporator fan motor draws air over the evaporator (cooling) coils and circulates the cold air through the refrigerator and freezer compartments.