Dryer drum drive belt. The belt is flat, 92-1/4 inches long, 1/4 inch wide and has 4 ribs and 3 grooves. It replaces many other belts, including some with 5 ribs and 4 grooves. If the drum does not turn, but you can hear the motor running then there is a good chance the belt has broken.
Rear drum support roller kit. This kit contains two drum support rollers. If the drum rollers are worn out, the dryer may not turn properly or may be excessively noisy. Be aware that the drum bearings are self-lubricating; it is not necessary to lubricate them yourself.
Dryer door catch kit. This kit includes three different door catches; you will need to select the door catch that fits your model.
Dryer belt tension idler pulley assembly.When the idler pulley goes bad it will usually make a high pitch squeeling or rattling noise.
Dryer lint screen assembly. Proper air flow is critical to dryer operation so the filter should be cleaned before every load.
Dryer drum drive motor. Includes pulley for dryer drum drive belt. Other shaft has reverse threads for blower wheel. Common symptoms of a bad drive motor are:
-Dryer stops turning during cycle
-Dryer won't start
-Dryer won't turn at all
-Dryer drive motor is loud
White touch-up paint. .6 oz.
Dryer blower wheel. Used on 29 inch Whirlpool built models with lint filter on top. To remove the blower wheel, unscrew the blower wheel clockwise off the motor shaft.
Dryer tri-ring retainer for drum support rollers.
Dryer heating element assembly, 240 volts. If the dryer does not heat check for a blown themal fuse or thermal cut out. Heating elements will often have a break in the coil element if defective.
Dryer door/washer lid switch kit. Comes with dryer mounting bracket, (2) wire terminals and (2) mounting screws.
Dryer foam seal with adhesive backing. This seals goes between the lint chute and the bulkhead. 28 in
Shaft for drum support roller, left side
Spray paint, white, 12 ounces