Rear drum support roller kit. This kit contains two drum support rollers. If the drum rollers are worn out, the dryer may not turn properly or may be excessively noisy. Be aware that the drum bearings are self-lubricating; it is not necessary to lubricate them yourself.
Dryer belt tension idler pulley assembly.When the idler pulley goes bad it will usually make a high pitch squeeling or rattling noise.
Refrigerator defrost timer kit. This timer is designed for continuous or cumulative run defrost systems. Turn the dial on the timer clockwise to advance it into and out of defrost.
Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.
Dryer foam seal with adhesive backing. This seals goes between the lint chute and the bulkhead. 28 in
Icemaker water fill tube with compression nut. Approximately 9 1/2 inches long. Can be cut to match the length of the original tube.
Refrigerator evaporator fan motor with blade. No LONGER comes with brackets. Must resuse old brackets. Instructions can be found on servicematters.com with part# W11500157.
37 in. vacuum cleaner attachment for condenser and dryer cleaning - This vacuum cleaner attachment will help to clean dust and lint build-up in and around your refrigerator condenser coils underneath the refrigerator and dryer lint in the area where the lint filter is inserted. Fits 1-1/4 in. vacuum