Furnace hot surface igniter kit. The igniter gets very hot and glows bright orange to light the gas burner. If the igniter is cracked or defective, the furnace won’t heat.
Furnace control board. The control board regulates the supply of power to the furnace components.
Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.
Gas Burner Tube
Draft inducer blower assembly. 60 Hz 1.75 Amps, 3000 RPM
Furnace blower motor. This single-phase motor has the following specifications:
Full-Load Amperage: 12.2
Shaft Length: 3.5”,
Gas valve kit
Run capacitor, Single, Oval, 370 Volts, 15 Microfarads
Orifice,burner drill size 45
Blower wheel, 11 x 10, cw, 1/2 bore
Blower motor mounting kit
Whl,blw 11x11,cw,1/2" bore
Transformer, 120 volt primary 24 volt secondary 40 va