Briggs & Stratton Original Equipment 492932S Oil Filter. Length: 2 1/4 inches. For optimum performance, we recommend changing the oil in your small engine after the first five hours of use. After that, change the oil on a yearly basis or after every 50 hours of use (whichever comes first).
Briggs & Stratton in-line fuel filter. The filter screen is on the large side of the housing. The port on the large side goes to the fuel tank while the port on the small side of the housing goes to the carburetor.
Briggs & Stratton rocker cover gasket. Be sure that all surfaces are clean and dry before installing this gasket. Do not use solvents or gasket sealer on this gasket.
Crankcase oil seal, PTO side
Briggs & Stratton Spark Plug (QC12YC)
Carburetor float bowl. If the carburetor is leaking, one of the float bowl gaskets may be worn out.
Briggs & Stratton carburetor (RUIXING) with fuel shut off solenoid. If the carburetor is clogged, the engine won't get enough fuel. As a result, the engine may not start or may run rough. The carburetor can often be cleaned or rebuilt, but may sometimes need to be replaced.
Ignition coil (or magneto armature). The ignition coil sends voltage to the spark plug while the engine is running. If the ignition coil is defective, the engine may not start.
Starter motor. When energized, the starter motor's drive gear engages the flywheel to start the engine. (Ensure that the solenoid wire is not being pinched upon installation of the starter, as this will potentially short the circuit)