Roller and axle assembly for lower dishrack.Used for rear rollers on some models.Some models use these rollers for the front and rear.
Rack slide end cap for upper dishrack. This end cap prevents the dishrack from sliding all the way out of the dishwasher.
Dishwasher door baffle. Located under dishwasher door on left-hand side. If this baffle is worn, damaged, or missing, the dishwasher will leak water.
Dishwasher door baffle. Located under dishwasher door on right-hand side. If the baffle is worn, damaged, or missing, the dishwasher will leak water.
Dishwasher dishrack roller kit, set of 4. These rollers allow the dishrack to move in and out of the dishwasher.
All purpose switch
Dishwasher water inlet valve, Replaces several discontinued GE water valves made since 1974.
Plunger and armature, drain solenoid
Dishwasher motor and pump kit. Note: This part may not look like your old motor and pump assembly. It is a new kit designed by the manufacturer to replace all of their dishwasher pumps since 1970. Instructions for adapting it to your dishwasher model are included.
Detergent cup cover
Push-on nut for dishwasher drain valve.
Shaft seal for dishwasher drain pump valve.
Detergent cup release arm
Piston assembly also referred to as a check valve assembly. If the check valve is wore out the dishwasher may not wash or drain properly.
Rinse dispenser fill cap