Dryer drum slide. There are two of these needed on your dryer. These go on the inner most slots on the front bearing. Sold individually will need to purchase two*. The drum slides support the front of the dryer drum instead of rollers or bearings. As they wear out the dryer will make more noise.
Dryer drum slide. There are two of these needed on your dryer. The dryer's drum slides help to support the front of the drum as it rotates. If the drum slides are worn out, the dryer will be noisy. Because the slides wear out at the same rate, we recommend replacing all of the slides together.
Rear drum bearing kit. *Bearing plate has slot in it for ground strap. The drum bearing supports the rear of the dryer drum. Over time, the drum bearing wears out. If the drum bearing is worn out, the dryer may make noise.
Dryer drive belt. This is the most common GE/Hotpoint dryer belt. 87" long and 1/4" wide. 4 ridges.The drive belt dries out over time. If the dryer belt cracks or breaks, the dryer drum will not be able to turn. If the dryer motor is running, but the drum won't rotate, the belt has likely broken.
Dryer idler pulley wheel. If the pulley wheel is worn down, it may cause the dryer to be excessively noisy.
All purpose switch
Gas dryer igniter assembly with bracket and wire harness. If the dryer does not heat then the igniter may have burned out. The burned spot is normally visible. Be aware the igniter is very fragile.
Dryer door catch kit
Dryer door strike.
Leveling leg, adjustable
Dryer gas valve solenoid coil. Has two terminals.
Gas valve solenoid coil 3 terminal
Handle, white. Snaps in place
Knob clip, also called an insert. If the clip is missing from the knob check on the control stem.