Dryer drum support roller kit. Includes two washers. When the drum rollers are worn out, they can cause the dryer to make a loud rumbling noise. Both rollers should be replaced at the same time. The roller does not need lubrication, the bearing is self-lubricating.
Dryer drive belt. The belt has a length of 91 5/8” and width 5/16”. The belt has 5 ridges. If the dryer drum won’t rotate, but the motor is running then the belt has likely broken.
Dryer drum roller axle. If the dryer is noisy this roller axle or the roller itself may be worn and require replacement.
Dryer front drum support glide. Order 2 when repairing the dryer. Be aware it requires a rivet tool to install the new glide and the tool must be purchased locally.
Snap retaining ring. Used to keep rollers and idler wheels in place
Idler pulley wheel and bearing. If the idler pulley wheel and/or bearing is defective, it may cause the dryer to be excessively noisy.
Dryer lint filter. This filter should be cleaned before every load to ensure proper airflow for dryer operation. If the lint filter is ripped or torn, replace it.
Light bulb, 10 watt. Small screw in base
Dryer door catch kit. Includes door catch and clip (plastic)
Three terminal door switch kit. Be aware that this switch replaces older 2 terminal switches.
Drum baffle, tall. For mounting screws see related parts below
Felt seal for dryer drum.
Blower wheel, 3-1/8” deep, 8” fin diameter, 7-1/8” hub diameter, 20 angled fins, ½” diameter motor shaft, 3/8” motor shaft diameter to flat side of shaft. Spring clamp not included.
Electric dryer power cord kit, 4 foot 30 Amp 3 wire w/closed eyelets & strain relief
Screw, 10-24 3/8