Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.
Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.
Dryer thermal fuse. If the dryer overheats, the thermal fuse blows to cut off power to the dryer. If the thermal fuse has blown, the dryer won't start. The thermal fuse cannot be reset—if the fuse has blown, it must be replaced.
Igniter (Bracket is no longer included.) If your old igniter was round you will need to order the bracket in the related parts below.
High limit thermostat, L225-40F
Dryer heating element kit with thermostat, thermal fuse and wires, 240 volt
Cycling thermostat, L135-15F
3 wire cycling thermostat with pre-heater L138-155
High-limit thermostat, L255
Heating element kit with thermostat, thermal fuse and wires, 208 volts
Cycling Thermostat, L140-15F
Timer control assembly
5 Cycle timer assembly