Washer drive belt. If this belt is broken, the washer will not spin or agitate.
Washing machine drain pump. On some models you will need to configure the replacement pump to match the old pumps outlet port direction and reuse the old mounting bracket. If the washer does not drain then the drain pump may be clogged, damaged, or defective.
Washing machine main tub seal assembly. If the washer leaks then the tub seal may be bad.
Water inlet valve. The water inlet valve opens to allow hot, cold or warm water to enter the washing machine. If the water inlet valve is defective, the washer may fill slowly or not fill at all.
Washing machine belt tension pulley assembly
Universal washing machine water supply hose set. Includes 2 extra strong 6 foot braided stainless steel hoses with hose washers already installed. It is recommended to replace washing machine inlet hoses after 5 years of use to reduce the risk of hose failure.
Upper spin bearing
Screw, pan head
Capacitor, washer motor 110 volt 233-280 mfd.
Drain hose with 90 degree elbow. 90 inches (7-1/2 feet) long
Bolt for trunnion block
Agitator drive block. If the drive block wears out the washers agitator will not work properly and may also make be noisy during operation.